SQL/MX 3.2 Messages Manual (H06.25+, J06.14+)

Utility Messages (20000 through 23099)
HP NonStop SQL/MX Release 3.2 Messages Manual—691121-001
19-10
SQL 20030
Cause. You specified a start key as HIGH_VALUES, which is not supported.
Effect. The operation fails.
Recovery. None. This is an internal error. Contact your service provider.
SQL 20031
Cause. You specified an end key as LOW_VALUES, which is not supported.
Effect. The operation fails.
Recovery. None. This is an internal error. Contact your service provider.
SQL 20032
Cause. SQL detected an internal error.
Effect. SQL is unable to process the statement.
Recovery. None. This is an internal error. Contact your service provider.
SQL 20033
Cause. You attempted to drop a nonemtpy range partition.
Effect. The operation fails.
Recovery. Make sure the range partition is empty before dropping it.
SQL 20034
Cause. The catalog is not visible on the local node, either because it does not exist or
because it exists elsewhere in the network and has not been registered on the local
node. This utility message corresponds to message 1002.
Effect. The operation fails.
20030 The specified start key cannot be HIGH_VALUES.
20031 The specified end key cannot be LOW_VALUES.
20032 An internal problem was detected.
20033 The partition must be empty before you drop it.
20034 Catalog does not exist or has not been registered on
the local node.