MX 3.x)

Installing, Starting, and Uninstalling MXCS

HP NonStop SQL/MX Connectivity Service Manual—640327-001

2-6

Starting the MXCS Service

-TMC alternate-collector-name

specifies the name of the alternate EMS collector to be used for server tracing

generated by MXCS. If option [-TMC alternate-collector-name] is not provided,

MXCS Server Trace sends trace messages to the primary EMS collector. You must

start the alternate collector before starting MXCS. If server tracing is enabled but

the alternate collector is not started, an error message is logged to the default

collector ($0). See Configuring Server Tracing on page 3-25.

Additional Information

•

After the MXCS service is started, you use NSM/web or MXCI to enable the MXCS

service.

•

Only the parameters described here are valid. The IN, OUT, stdin, stdout, or stderr

parameters are not recognized by MXCS.

•

If you specify an invalid value for any parameter, the default value is used (if

available). If the parameter has no default value, MXOAS terminates with an error.

•

When the MXCS service is started, it then starts the other MXCS server

components, as specified in the configuration. When the server components are

started and available, the MXCS service is ready to accept incoming connections.