TS/MP 2.5 Management Programming Manual

8 Pathway Subsystem Control Commands
This section describes the commands that enable you to define and control the PATHMON process
and the Pathway subsystem:
Object TypesCommands
ZPWY-OBJ-PMZPWY-CMD-CONTROL
ZSPI-VAL-NULL-OBJECT-TYPE
nl
ZPWY-CMD-GETVERSION
ZPWY-OBJ-PM
ZPWY-OBJ-PATHCTL
nl
ZPWY-CMD-INFO
ZPWY-OBJ-PATHWAY
ZPWY-OBJ-PATHWAYZPWY-CMD-SHUTDOWN2
ZPWY-OBJ-PATHWAYZPWY-CMD-START
ZPWY-OBJ-LM
nl
ZPWY-CMD-STATUS
ZPWY-OBJ-PATHWAY
nl
ZPWY-OBJ-PM
nl
ZPWY-OBJ-PMREQUESTER
ZPWY-OBJ-PATHWAY
nl
ZPWY-CMD-STOP
ZPWY-OBJ-PM
ZPWY-OBJ-PMZPWY-CMD-SWITCH
With these commands you can:
• Set the limits for the number of Pathway subsystem objects
• Specify PATHMON process logging attributes
• Display PATHMON process and Pathway subsystem attributes and status information
• Designate and change the CPU where the PATHMON backup process runs
For a brief description of each object type listed, see “Object Types” (page 32).
CONTROL PM
Use the CONTROL PM command to change specific attributes of the PATHMON process while it
is running and to record the changes in the PATHMON configuration file.
Continuation
You cannot use continuation with this command.
Command Syntax
For tokens that may be present in the command and response buffers but are not listed, see “Unlisted
Tokens” (page 49). For descriptions of tokens and fields, see “SPI and EMS Standard Definitions”
(page 50) to “ZPWY-MAP- Definitions” (page 75).
Command
nl
ZPWY-CMD-CONTROL
Object Type
nl
ZPWY-OBJ-PM
Tokens in Command Buffer
nl
ZPWY-MAP-PAR-CONTROL-PM token-type ZPWY-DDL-PAR-CONTROL-PM.
!r
CONTROL PM 117