TS/MP 2.5 Management Programming Manual

For a description of tokens that are present in this event message but are not listed or described
below, see “Event Management” (page 163).
ZSPI-TKN-ERRLIST token-type ZSPI-TYP-LIST.
ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR.
ZPWY-TKN-REQCOMMAND token-type ZSPI-TYP-INT.
ZPWY-TKN-REQOBJECTTYPE token-type ZSPI-TYP-UINT.
ZPWY-TKN-REQnnnNAME token-type ZPWY-TYP-nnnNAME.
ZPWY-TKN-ERRCOMMAND token-type ZSPI-TYP-INT.
ZPWY-TKN-ERROBJECTTYPE token-type ZSPI-TYP-UINT.
ZPWY-TKN-nnnNAME token-type ZSPI-TYP-nnnNAME.
ZPWY-TKN-ERRINFO token-type ZSPI-TYP-INT.
ZSPI-TKN-ENDLIST token-type ZSPI-TYP-SSCTL.
Token Descriptions
ZSPI-TKN-ERROR contains ZPWY-ERR-PM-INTERNAL.
ZPWY-TKN-ERRINFO contains the value of the P-register at the time the error occurred.
Effect. The PATHMON process creates a memory dump if dumping is enabled.
Recovery. Contact your HP support representative.
1026: ZPWY-ERR-PM-BADMSG
A message received does not conform to the PATHMON request protocol. This error can be caused
by running incompatible versions of PATHCOM, PATHMON, or PATHTCP. The message was
received from the process running under the specified user ID.
This error does not appear as an error list; it appears only in the RETCODE token in response to
a command that is using continuation.
Effect. The PATHMON process rejects the request.
Recovery. Contact your HP support representative.
1031: ZPWY-ERR-PM-MISSINGPARAM
A required Pathway configuration parameter is not defined.
For a description of tokens that are present in this event message but are not listed or described
below, see “Event Management” (page 163).
ZSPI-TKN-ERRLIST token-type ZSPI-TYP-LIST.
ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR.
ZPWY-TKN-REQCOMMAND token-type ZSPI-TYP-INT.
ZPWY-TKN-REQOBJECTTYPE token-type ZSPI-TYP-UINT.
ZPWY-TKN-REQnnnNAME token-type ZPWY-TYP-nnnNAME.
ZPWY-TKN-ERRCOMMAND token-type ZSPI-TYP-INT.
ZPWY-TKN-ERROBJECTTYPE token-type ZSPI-TYP-UINT.
ZPWY-TKN-nnnNAME token-type ZSPI-TYP-nnnNAME.
ZSPI-TKN-ENDLIST token-type ZSPI-TYP-SSCTL.
Token Descriptions
ZSPI-TKN-ERROR contains ZPWY-ERR-PM-MISSINGPARAM.
Effect. The command fails.
Recovery. Define the required parameter.
1032: ZPWY-ERR-PM-NODISKSPACE
An entry cannot be added because the PATHMON configuration file is full. This is a Pathway
subsystem internal error.
Error-Message Range 1000 Through 1999 233