TS/MP 2.5 Management Programming Manual

ManualsBrandsHP ManualsServerHP Integrity NonStop J-Series

241

242

243

244

245

246

247

248

249

250

1073: ZPWY-ERR-PM-CHECKOPEN

A Guardian error occurred during the execution of a CHECKOPEN procedure.

This error does not appear as an error list; it appears only in the RETCODE token in response to

a command that is using continuation.

Effect. The primary file is closed. Additional effects depend on the file being opened.

Recovery. For information about the specified CHECKOPEN error, see the Guardian Procedure

Calls Reference Manual.

1074: ZPWY-ERR-PM-CHECKCLOSE

A Guardian error occurred during the execution of a CHECKCLOSE procedure.

This error does not appear as an error list; it appears only in the RETCODE token in response to

a command that is using continuation.

Effect. None.

Recovery. For information about the specified CHECKCLOSE error, see the Guardian Procedure

Calls Reference Manual.

1078: ZPWY-ERR-PM-INTERNALFATAL

A PATHMON process internal consistency check failed. This is a Pathway subsystem internal error.

For a description of tokens that are present in this event message but are not listed or described

below, see “Event Management” (page 163).

ZSPI-TKN-ERRLIST token-type ZSPI-TYP-LIST.

ZSPI-TKN-ERROR token-type ZSPI-TYP-ERROR.

ZPWY-TKN-REQCOMMAND token-type ZSPI-TYP-INT.

ZPWY-TKN-REQOBJECTTYPE token-type ZSPI-TYP-UINT.

ZPWY-TKN-REQnnnNAME token-type ZPWY-TYP-nnnNAME.

ZPWY-TKN-ERRCOMMAND token-type ZSPI-TYP-INT.

ZPWY-TKN-ERROBJECTTYPE token-type ZSPI-TYP-UINT.

ZPWY-TKN-nnnNAME token-type ZSPI-TYP-nnnNAME.

ZPWY-TKN-ERRINFO token-type ZSPI-TYP-INT.

ZSPI-TKN-ENDLIST token-type ZSPI-TYP-SSCTL.

Token Descriptions

ZSPI-TKN-ERROR contains ZPWY-ERR-PM-INTERNALFATAL.

ZPWY-TKN-ERRINFO contains the value that was in the P register at the time of the failure.

Effect. The PATHMON process terminates. If memory dumping is enabled, the PATHMON process

creates a dump file before terminating.

Recovery. Contact your HP support representative.

1079: ZPWY-ERR-PM-NOSTATICSCPROCESS

A START SC command failed because the ZNUMSTATIC field in ZPWY-DDL-DEF-SC is set to 0.