TS/MP 2.5 Management Programming Manual

ZACL-TKN-EVENT-PROCESS-NAME contains the name of the PATHMON process. This token is
the subject of the event message.
Effect. If the MAT message was sent in response to an operational command from PATHCOM or
from SPI requesters, the command fails. PATHMON logs an EMS event.
Recovery. No recovery action is required.
1029: ZACL-EVT-CPU-STARTED
The ACS subsystem processes in the specified CPU were started in response to a START command
or were restarted in response to a CONTROL command.
Unconditional Tokens
ZACL-TKN-EVENT-LEVEL token-type ZACL-TYP-EVENT-LEVEL.
ZACL-TKN-EVENT-CPU-NUMBER token-type ZSPI-TYP-INT.
Event-Message Text
1029 - Core processes started in CPU cpu-number
Token Descriptions
ZACL-TKN-EVENT-LEVEL has the value of ZACL-VAL-EVENT-LEVEL-STATUS.
ZACL-TKN-EVENT-CPU-NUMBER contains the number of the physical CPU that was started
on the system where the event message was generated. This
token is the subject of the event message.
Effect. Pathsend operations initiated in the CPU no longer fail with FESCLINKMONCONNECT
errors.
Recovery. This is an informational message only; no corrective action is needed.
EMS Messages 1030 to 1039
1030: ZACL-EVT-CPU-STOPPED
One or all of the ACS subsystem processes in a CPU on the local system failed or were stopped
in response to a STOP command. If due to a failure, the physical CPU may have failed.
Unconditional Tokens
ZACL-TKN-EVENT-LEVEL token-type ZACL-TYP-EVENT-LEVEL.
ZACL-TKN-EVENT-CPU-NUMBER token-type ZSPI-TYP-INT.
Event-Message Text
1030 - Core processes stopped in CPU cpu-number
Token Descriptions
ZACL-TKN-EVENT-LEVEL has the value of ZACL-VAL-EVENT-LEVEL-ERROR.
ZACL-TKN-EVENT-CPU-NUMBER contains the number of the physical CPU in which the ACS
subsystem processes were stopped on the system where the
event message was generated. This token is the subject of
the event message.
Effect. Pathsend operations initiated in the CPU fail with FESCLINKMONCONNECT errors until
the core processes are restarted.
Recovery. Use the CONTROL ACS command to restart the ACS subsystem processes in the CPU.
286 ACS Subsystem Messages