TS/MP 2.5 Management Programming Manual

02 ZCURPARAMS
02 ZCURPATHCOMS
token-type ZPWY-DDL-0-4095.
token-type ZPWY-DDL-0-4095.
02 ZCURPROGRAMS token-type ZPWY-DDL-0-100.
02 ZCURSERVERCLASSES token-type ZPWY-DDL-0-4095.
02 ZCURSERVERPROCESSES token-type ZPWY-DDL-0-4095.
02 ZCURSPI token-type ZPWY-DDL-0-4095.
02 ZCURSTARTUPS token-type ZPWY-DDL-0-100.
02 ZCURTCPS token-type ZPWY-DDL-0-4095.
02 ZCURTELLS token-type ZPWY-DDL-0-4095.
02 ZCURTERMS token-type ZPWY-DDL-0-4095.
02 ZMAXDEFINES token-type ZPWY-DDL-0-4095.
02 ZCURDEFINES token-type ZPWY-DDL-0-8191.
02 ZNODEINDEPENDENT token-type ZPWY-DDL-0-8191.
02 ZDUMASK token-type ZPWY-DDL-ON-OFF.
02 ZSPREBALANCEMODE
end.
token-type ZPWY-DDL-OCTALNUM-VALUE.
token-type ZPWY-DDL-RBMODE-VALUE.
ZBACKUPCPU
specifies the CPU in which the PATHMON backup process runs.
ZDUMPINFO
specifies information about dump files. The fields are described under
“ZPWY-DDL-DUMP-INFO” (page 62).
To reset this field using the TACL program, you must use the #SETBYTES built-in
function. For more information, see the SPI Programming Manual.
ZMAXASSIGNS
is the maximum number of ADD SCASSIGN definitions that you can specify for all
server classes in the PATHMON environment. This field has the same meaning as
the MAXASSIGNS parameter in the PATHCOM SET PATHWAY command.
The value must be a number from 0 to 8191. The maximum number of ASSIGN
messages allowed by Pathway for all server classes is 8191.
This field is mandatory.
ZMAXEXTERNALTCPS
this field applies only to Pathway/iTS; a complete description is given in the
Pathway/iTS Management Programming Manual. If you do not have Pathway/iTS
installed, then HP recommends setting this value to zero, which is the default value.
ZMAXLINKMONS
is the maximum number of LINKMON processes or ACS subsystem processes that
can communicate with the PATHMON process at the same time. LINKMON
processes or ACS subsystem processes manage communication between Pathway
subsystem server classes and all Pathsend requesters running within the processor
of these processes. This field has the same meaning as the MAXLINKMONS parameter
in the PATHCOM SET PATHWAY command.
Valid values for ZMAXLINKMONS range from 0 to 800. A maximum of 255
LINKMON processes or ACS subsystem processes are allowed to concurrently hold
links to a single server process. For other limits, see “Configuration Limits and
Defaults” (page 372).
If no value is assigned to this field, then the default value is zero; any attempt by
a LINKMON processes or ACS subsystem processes to access a server controlled
by this PATHMON process fails.
ZMAXPARAMS
78 ZPWY-MAP- Definitions