TS/MP 2.5 Management Programming Manual

ZMAXSTARTUPS
is the maximum number of server classes that can have STARTUP messages.
The value must be a number from 0 to 4095. To enable PATHMON process to run
the equivalent of the PATHCOM ALTER SERVER STARTUP command, specify a
maximum of 4094 for this attribute.
Because only one STARTUP definition for each server class counts toward this limit,
the number for this field not exceed the value for ZMAXSERVERCLASSES.
This is a required field; no default.
ZMAXTCPS
this field applies only to Pathway/iTS; a complete description is given in the
Pathway/iTS Management Programming Manual. If you do not have Pathway/iTS
installed, then HP recommends setting this value to zero.
This is a required field; no default.
ZMAXTELLQUEUE
this field applies only to Pathway/iTS; a complete description is given in the
Pathway/iTS Management Programming Manual. If you do not have Pathway/iTS
installed, then HP recommends setting this value to zero; the default value is 4.
ZMAXTELLS
this field applies only to Pathway/iTS; a complete description is given in the
Pathway/iTS Management Programming Manual. If you do not have Pathway/iTS
installed, then HP recommends setting this value to zero; the default value is 32.
ZMAXTERMS
this field applies only to Pathway/iTS; a complete description is given in the
Pathway/iTS Management Programming Manual. If you do not have Pathway/iTS
installed, then HP recommends setting this value to zero.
This is a required field; no default.
ZMAXTMFRESTARTS
this field applies only to Pathway/iTS; a complete description is given in the
Pathway/iTS Management Programming Manual. If you do not have Pathway/iTS
installed, then HP recommends setting this value to zero; the default value is 5.
ZOWNER
is the user ID allowed to issue commands that directly alter the state of the
PATHMON-controlled objects. The user ID must be known to the system in which
your program is running. The value of the ZOWNER field works in conjunction with
the value you set for the ZSECURITY field.
For more information on this field, see the “ZPWY-DDL-OWNER-ID” (page 65).
If you do not assign a value to this field, then the default is the owner ID of the user
who started the PATHMON process.
ZSECURITY
specifies the users who can issue commands that directly alter the state of the
Pathway subsystem objects. Before you issue the START PATHWAY command, the
owner ID is the process-accessor ID of the PATHMON process and the security
attribute is ZPWY-VAL-U (user). This security setting prevents alteration of the
PATHMON configuration file and allows a remote requester to start the PATHMON
environment.
80 ZPWY-MAP- Definitions