G06.24 ReadMe

name: Filter De-register For IPv6 Address ip-addr Failed,

Error = err-code, Filter Type = type Local Port = port.

Cause: A filter de-registration failed on subnet name foripv6-addr.

This event could be due to an improperly configured NonStop TCP/IPv6

subsystem or an internal NonStop TCP/IPv6 subsystem problem.

Effect: None.

Recovery: Determine the type and the cause of the failed registration

from the err-code value and take the appropriate action.

218 (Critical Event)

Device lif-name MAC Address Changed, Operator Intervention Required,

Subnet will remain in the STARTING state.

Cause: A LAN adapter was replaced, but the operator did not first use

SCF to STOP the subnet that was using the LIF on the adapter.

Effect: The subnet is unusable until the operator takes corrective

action.

Recovery: Using SCF, the operator must first STOP the subnet, then

DELETE it, re-ADD it, and START it again.

219 (Noncritical Event)

ND6HOSTD Process Running: function-name,

programfilename = program-filename, tcip = tcpip-name.

resconf = resconf-filename, debug = debug-info

Cause: A running process displays configuration information.

Effect: None.

Recovery: This is an informational message only; no operator

intervention is required.

220 (Critical Event, Noncritical)

ND6HOSTD Process Terminating. function-name, text

Cause: The ND6HOSTD process is terminating because of an un-

recoverable error or because of an operator initiated request.

Effect: The ND6HOSTD process is stopped.

Recovery: If the ND6HOSTD is configured as a persistent process, the

persistence manager restarts the process. If the process terminated

due to an unrecoverable error condition, an EMS event message

generated prior to this event describes the error condition.

221 (Critical Event)

ND6HOSTD Configuration Error:

function-name: config-err-info, params

Cause: A configuration error was detected. The config-info field

indicates the cause.

Effect: The process terminates or stops.

Recovery: Check for errors in the STARTUPMSG and restart the process.

222 (Critical Error)

Page