G06.24 ReadMe

4. Run install^templates to create updated template files:
tacl>Install^templates newres newnres $system.ztempl
---Launching a Startup TACL from the TSM Low-Level Link---
When launching a Startup TACL from the TSM Low
-Level Link, with
OutsideView 7.1, there is no echo initially. Workarounds include:
-Upon successful logon, the echo should appear.
-Press the Return key, then re-enter your command (repeat two or
three times, if echo doesn't appear).
-Retry the Startup TACL menu option in the TSM Low-Level Link
---NonStop TCP/IPv6 Messages---
The messages described below were inadvertently omitted from the
current version of the Event Detail Data Base, (T8644AAN).
The messages in this section are generated by the NonStop TCP/IPv6
subsystem. The subsystem ID displayed by these messages includes ZTC6
as the subsystem name.
For further information regarding all of the following messages, refer
to Section 112, TCP/IPv6 Messages, in the G06.24 Operator Messages
Manual.
-3 (Noncritical Event)
subnet changed from old-state to new-state reason.
Cause: The summary state of a NonStop TCP/IPv6 subnet has changed
because of a command or an error.
Effect: None.
Recovery: If an operator command caused the summary-state change,
no action is necessary. If the state changed for any other reason,
note down the error description in the accompanying event message
that is returned and contact your service provider.
1 (Critical Event)
TCPIPv6 no longer operational on CPU cpu-num, cause
Cause: The NonStop TCP/IPv6 monitor process detected an internal
error in the subsystem and has halted the processor. The NonStop
TCP/IPv6 subsystem could not recover.
Effect: All the established NonStop TCP/IPv6 connections through
that processor are lost.
Recovery: Restart the NonStop TCP/IPv6 subsystem on the processor
where the event occurred and send the online processor dump file to
your service provider for analysis.
2 (Critical Event)
ARP: Duplicate IP address ip
-addr from Ethernet address enet-addr.
Page
9
of
21