H06.04 Software Installation and Upgrade Guide

Contents

H06.04 Software Installation and Upgrade Guide—541607-001

B. Installing SWID, DSM/SCM PVU, and Planner

Interface (PI) Client Software

Install SPRs With DSM/SCM (continued)

Build the New Revision A-5

Print Operator Instructions From the Target Interface (ZPHITI) A-6

Run ZPHIRNM A-6

If Running INSTALL^TEMPLATES Is Required A-7

If a System Load Is Required A-9

Halt the Processors A-9

Perform a System Load A-10

Start Your Applications and Processes A-10

B. Installing SWID, DSM/SCM PVU, and Planner Interface (PI)

Client Software

Alerts B-1

Determine the Product Version of DSM/SCM on the Host System B-1

Determine the Latest SWID Product B-2

Determine the Product Version of DSM/SCM on the Client B-3

Copy (RESTORE) the H01 DSM/SCM Product Version to Disk (If Necessary) B-4

Receive the H01 SWID and DSM/SCM SPRs B-4

Create a New Software Revision for DSM/SCM H01 and SWID SPRs B-7

Build and Apply the DSM/SCM H01 Software Product Revision B-7

Rename the Applied DSM/SCM H01 Files By Running ZPHIRNM B-9

Run the INSTALL^TEMPLATES Macro B-9

Restart Applications B-10

Before Starting DSM/SCM B-10

Start DSM/SCM B-10

Verify That the H01 PVU of DSM/SCM Is Installed B-11

Verify That SWID Is Installed

B-12

Recovery for Problems While Installing the H01 Version of DSM/SCM

B-12

If NonStop Errors Are Displayed B-12

Install the DSM/SCM Client From ZDSMSCM B-13

Alert (DSM/SCM T6031G01/H01 Client) B-13

Determine Your DSM/SCM Client Software Version B-13

Determine the Current IP Address and Port Number B-13

Copy the ZDSMSCM Client File From the Host B-14

Install the DSM/SCM Client Software B-15

Create an Emergency Repair Disk (ERD) or Automated System Recovery (ASR)

Disk B-20