H06.05 Software Installation and Upgrade Guide

Resuming Normal Operations
H06.05 Software Installation and Upgrade Guide—541762-003
7-4
Update NonStop TCP/IP Configuration Files
To copy the sample files:
>FUP DUP $SYSTEM.ZTCPIP.SMPLHOST, $SYSTEM.ZTCPIP.HOSTS
>FUP DUP $SYSTEM.ZTCPIP.SMPLPROT, $SYSTEM.ZTCPIP.PROTOCOL
>FUP DUP $SYSTEM.ZTCPIP.SMPLNETW, $SYSTEM.ZTCPIP.NETWORKS
>FUP DUP $SYSTEM.ZTCPIP.SMPLPORT, $SYSTEM.ZTCPIP.PORTCONF
>FUP DUP $SYSTEM.ZTCPIP.SMPLRESC, $SYSTEM.ZTCPIP.RESCONF
>FUP DUP $SYSTEM.ZTCPIP.SMPLSERV, $SYSTEM.ZTCPIP.SERVICES
Step 2: Check the PROTOCOL File (Optional)
If the PROTOCOL configuration file exists in $SYSTEM.ZTCPIP, you must add two
lines from the sample PROTOCOL file (SMPLPROT). Find the lines in SMPLPROT
from the SUT that refer to IPV6 and ICMPV6 and copy those lines into your
$SYSTEM.ZTCPIP.PROTOCOL file. For example:
12> TYPE SMPLPROT
#
# @(#)protocols 1.1 Tandem
#
# Internet (IP) protocols
# This file is never consulted when the yellow pages are running
#
ip 0 IP # internet protocol, pseudo protocol number
icmp 1 ICMP internet control message protocol
ggp 3 GGP gateway-gateway protocol
tcp 6 TCP transmission control protocol
pup 12 PUP PARC universal packet protocol
udp 17 UDP user datagram protocol
ipv6 41 IP internet protocol for v6
icmpv6 58 ICMP internet control message protocol for v6
Step 3: Ensure That PORTCONF and SERVICES Files Are
Complete
The PORTCONF file specifies the ports that the LISTNER process listens to and the
corresponding server program it invokes when the request comes in.
If you copied files as documented in Step 1, for the DSM/SCM Planner Interface to
work, you must add a services line corresponding to DSM/SCM in the PORTCONF file
(shown in bold lettering) and save the file. If you did not copy the files as documented
in Step 1, no action is necessary. An example of the PORTCONF file:
Caution. Even if you are running TCP/IPv6 in IPv4 or conventional TCP/IP mode, you must
make sure that the PROTOCOL file contains ipv6 and icmpv6 entries. If these entries are
absent, a network failure might occur because the new socket routines present in TELSERV,
LISTNER, and FTP access the entries in the PROTOCOL file.