H06.05 Software Installation and Upgrade Guide

Backing Out the DSM/SCM Revision
H06.05 Software Installation and Upgrade Guide—541762-003
8-2
Before Backing Out the Revision
Before Backing Out the Revision
1. Confirm that the spooler is active and not 100 percent full.
a. At a TACL prompt, start SPOOLCOM and issue a COLLECT, STATUS
command. For example:
12> spoolcom $spls; collect, status
COLLECT STATE FLAGS CPU PRI UNIT DATA FILE %FULL
$S ACTIVE 3 , 1 154 4 $OPS0.SPL.DATA 4
b. If the spooler is not active, start the spooler.
You will use the spooler to print out operator instructions when backing out the
revision.
2. Start the TMF subsystem and DSM/SCM if they are not already running. For
example:
4> TMFCOM START TMF
5> volume $dsmscm_vol.ZDSMSCM
6> RUN STARTSCM
where $dsmscm_vol is the DSM/SCM volume.
Start the Target Interface (ZPHITI)
1. From the DSM/SCM subvolume, enter:
RUN ZPHITI
The TI Logon screen appears:
DSM Software Configuration Manager TI
Logon
==============================================================================
User ID:______________________
Password:____________
==============================================================================
==============================================================================
This software is licensed by Hewlett Packard Development Company L.P. and
is subject to restrictions on use, disclosure and copying and is Commercial
Software. If a user is an entity of the United States Government, only
LIMITED RIGHTS or RESTRICTED RIGHTS are granted.
HP and the HP logo are trademarks of
Hewlett Packard Development Company L.P.
T6031H01 11NOV2004
(c) Hewlett Packard Development Company L.P., 1994-2004
All Rights Reserved
==============================================================================
F1-Logon F8-Clear entry
F15-Help SF16-Exit
Ready