H06.05 Software Installation and Upgrade Guide

H06.05 Software Installation and Upgrade Guide—541762-003
10-1
10
Loading the Previous RVU and
Resuming Normal Operations
This section describes how to perform a system load of the previous RVU of the
NonStop operating system into the memory of each processor in an Integrity NonStop
NS-series server.
Alerts
Before performing a system load:
•
Before halting the processors, stop running applications, including TMF.
•
Do not close the System Startup dialog box while startup is in progress. If you
attempt to close the dialog box, a message dialog box appears to alert you that the
system startup process will be stopped if you continue.
•
If you stop a system startup before it has finished, the state of your system will be
unpredictable. You might need to perform another system startup to enable the
system to resume normal operation.
•
If you must stop the system startup process, click Abort. (The abort process
should take effect within 30 seconds.)
•
For detailed information on performing a system load of an Integrity NonStop
NS-series server, see Section 15 in the NonStop NS-Series Operations Guide.
Note. To stop TMF, at a TACL prompt, enter:
5> TMFCOM STOP TMF
Caution. If your intent is to remain on the H06.04 RVU, the NonStop Blade Complex firmware
must be reverted back as explained under Reverting to H06.04 NonStop Blade Complex
Firmware on page 10-4.