H06.05 Software Installation and Upgrade Guide

Installing SWID, DSM/SCM PVU, and Planner
Interface (PI) Client Software
H06.05 Software Installation and Upgrade Guide—541762-003
B-9
Rename the Applied DSM/SCM H02 Files By
Running ZPHIRNM
Rename the Applied DSM/SCM H02 Files By
Running ZPHIRNM
1. Stop DSM/SCM:
> VOLUME $dsmscm_vol.ZDSMSCM
> RUN STOPSCM
where $dsmscm_vol is the DSM/SCM volume.
2. Run ZPHIRNM:
> RUN ZPHIRNM $volume.SYSnn
where SYSnn is the current SYSnn (because no SYSGEN or system load is
required).
3. When asked if you want to use a log file with the session, enter Y.
4. When prompted, enter a file name for the log file.
ZPHIRNM displays this message:
Log file, filename, was successfully created.
ZPHIRNM processes the file renaming.
5. Verify that ZPHIRNM ran successfully by reviewing the specified log file. For an
example of output, see ZPHIRNM on page 5-4.
Run the INSTALL^TEMPLATES Macro
EMS templates are used by EMS to format EMS messages. After running ZPHIRNM,
and if notified to do so by DSM/SCM, run the INSTALL^TEMPLATES TACL macro to
install DSM/SCM EMS templates in their proper locations.
The INSTALL^TEMPLATES macro is located in the $SYSTEM.ZINSAIDS subvolume
and invokes the TEMPLI program to build new resident and nonresident EMS template
files.
You must be logged on as a super.super (255, 255) user to run the
INSTALL^TEMPLATES macro. This macro cannot be run with the NOWAIT option and
takes approximately ten minutes to finish.
For detailed instructions on running the INSTALL^TEMPLATES macro, including
troubleshooting information, see If Running INSTALL^TEMPLATES Is Required on
page A-7.
Note. The files newres and newnres are used as temporary names until the next SYSGEN
and system load.