H06.05 Software Installation and Upgrade Guide

Contents
H06.05 Software Installation and Upgrade Guide—541762-003
iii
4. Installing a SUT for the H06.05 RVU
Verify System Processes (continued)
Verify Firmware 3-7
Verify Critical System Processes 3-7
Verify Disk Drives 3-8
Verify Tape Drives (If Necessary) 3-8
Check the Status of the Spooler Collector 3-9
Check for Sufficient Swap File Space 3-9
Install Node Interoperability SPRs 3-10
3-11
4. Installing a SUT for the H06.05 RVU
Alerts for Installing a SUT 4-1
Back Up Important Files 4-2
Receive New Software Into the Archive 4-2
Create a New Software Revision 4-6
Build and Apply the New Software Revision 4-11
Print Operator Instructions From the Target Interface (ZPHITI) 4-16
Recovery for Problems Installing an H06.05 SUT or SPRs 4-18
Cancel Pending Build/Apply Requests 4-18
5. Running ZPHIRNM
Alerts 5-1
Back Up (Copy) Files in the $SYSTEM.ZTCPIP Subvolume (Best Practice) 5-2
Stop Applications 5-3
Drain the Spooler (Optional) 5-3
Back Up the Spooler Control Files 5-4
ZPHIRNM 5-4
Using ZPHIRNM PREVIEW Mode 5-4
Steps for Running ZPHIRNM 5-6
Verify That ZPHIRNM Ran Successfully 5-7
6. Loading the H06.05 RVU
Alerts 6-2
Halt the Processors 6-3
Loading the System 6-3
Steps for Loading the System 6-3
Completing the System Load (If Necessary) 6-5
Verifying That the System Is Started 6-6