H06.06 Software Installation and Upgrade Guide

Overview of Installing the H06.06 RVU
H06.06 Software Installation and Upgrade Guide—542652-002
1-17
Managing Firmware in a NonStop Blade Complex
c. In the Management Window, double-click the system button (labeled
with the system name).
d. Right-click the GRP-400 button.
e. Select the Actions option.
f. From the GRP-400 actions list, select Power Cycle All Processors.
g. Click Perform Action.
h. Click OK when asked “Are you sure you want to do a Power Cycle All
Processors?”
i. When the Action Status box confirms that the power cycle has
successfully completed, close the dialog box.
3. Load (coldload) the system with the H06.06 RVU.
c. Update NonStop Blade Complex (NSBC) firmware on the other flash, as
follows:
1. Using the OSM Service Connection and the Blade Complex Firmware
Update guided procedure, complete the dialog boxes and update the
shadow firmware on each NonStop Blade Element.
2. Using the Switch Blade Element Firmware Images dialog box, select NO.
3. Repeat Steps 1and 2 for the other NonStop Blade Complexes.
NonStop Blade Complex Firmware Update for Migrations
From H06.05 to H06.06
To start and complete the Blade Complex Firmware Update guided procedure:
1. In the tree pane of the OSM Service Connection, right-click the Blade Complex
resource.
2. From the shortcut menu, select Actions.
Note. It should take approximately five minutes for all processors to complete
Power On initialization.
Note. OSM will preselect all the firmware that it detects as down-rev.
Note. Update all NonStop Blade Elements in the complex at this time.
Caution. Do not power cycle any NonStop Blade Element until the firmware update is
complete. If you interrupt or stop the procedure before the firmware update is completed, the
NonStop Blade Element firmware will be left in an incomplete and inconsistent state. Also, if
there is an interruption during the firmware update, do not reset or power cycle the NonStop
Blade Elements. Instead, immediately start the procedure from the beginning.