H06.07 Software Installation and Upgrade Guide

Resuming Normal Operations
H06.07 Software Installation and Upgrade Guide—543449-001
7-2
Start DSM/SCM
Cold Start the Pathway Configuration
1. Verify your current configuration against the cold start configuration in PATHHOST
(or PATHTARG) to check that the current configuration reflects all changes you
have made.
2. Run the PATHCOLD macro from the ZDSMSCM subvolume to cold start the
Pathway configuration.
Start DSM/SCM
1. From the ZDSM/SCM subvolume, start DSM/SCM:
> RUN STARTSCM
Because the $ZHOME reliable home-term process is not an interactive process
and is always paused, no action is necessary.
2. Press Enter. STARTSCM automatically runs the IP6031 TACL macro. This step
can take several minutes.
Run merge_whatis
After coldloading the system, run the OSS merge_whatis command. (ZPHIRNM
notifies you if you need to run it.) (The merge_whatis command is a shell script in
/bin that creates and updates the whatis database used by the OSS shell man,
apropos, and whatis commands.) You might have a shell script that runs either one
or both of the following, depending on your OSS environment:
/bin/merge_whatis
1. Log on to OSS as the super ID (255,255):
Current volume is $SYSTEM.STARTUP
$SYSTEM STARTUP 1> osh
2. Change directories by using the cd command. For example:
/G/SYSTEM/STARTUP: cd /usr/share/man
3. Run the merge_whatis command:
/usr/share/man: merge_whatis
Note. You can run the Pcleanup utility on any file that is managed and audited by DSM/SCM
before running the merge_whatis command. However, the OSS utility, Pcleanup cleans up
OSS files, but not DSM/SCM files, in the OSS file system. Only the DSM/SCM CLEANOSS
macro cleans up DSM/SCM files in the OSS file system. The CLEANOSS macro is run only if
you fall back and then migrate again to a new PVU. During a Build/Apply, DSM/SCM
automatically prompts you to run the CLEANOSS macro.