Manualshelf

H06.08 Software Installation and Upgrade Guide

ManualsBrandsHP ManualsServerHP Integrity NonStop Release and Migration
141142143144145146147148149150
Loading the Previous RVU and Resuming Normal
Operations
H06.08 Software Installation and Upgrade Guide—543573-001
11- 6
Reverting to H06.05 From H06.08
1. Using the OSM Service Connection and the Blade Complex Firmware
Update guided procedure, complete the dialog boxes and update the
shadow firmware on each NonStop Blade Element.
2. Using the Switch Blade Element Firmware Images dialog box, select NO.
3. Repeat Steps 1and 2 for the other NonStop Blade Complexes.
Reverting to H06.05 From H06.08
To start and complete the Blade Complex Firmware Update guided procedure:
1. In the tree pane of the OSM Service Connection, right-click the Blade Complex
resource.
2. From the shortcut menu, select Actions.
3. When the Actions window appears, select Firmware Update from the Available
Actions list.
4. Click Perform action.
5. In the guided procedures interface, click Start in the Procedure Tasks List pane.
6. Follow and complete the guided procedure dialog boxes using this summary:
a. Using the OSM Service Connection and the Blade Complex Firmware Update
guided procedure, complete the dialog boxes and update the shadow firmware
on each NonStop Blade Element.
b. Using the Switch Blade Element Firmware Images dialog box, select Yes to
switch the NonStop Blade Element image from shadow to running.
Note. In the Select Firmware Modules for shadow image dialog box, select all
parts that are noted as Up-Rev.
Note. Update all NonStop Blade Elements in the complex at this time.
Caution. Do not power cycle any NonStop Blade Element until the firmware update is
complete. If you interrupt or stop the procedure before the firmware update is completed, the
NonStop Blade Element firmware will be left in an incomplete and inconsistent state. Also, if
there is an interruption during the firmware update, do not reset or power cycle the NonStop
Blade Elements. Instead, immediately start the procedure from the beginning.
Note: HP recommends that you update all the NonStop Blade Elements at the same
time.