H06.08 Software Installation and Upgrade Guide

H06.08 Installation, Migration, and Fallback
Considerations
H06.08 Software Installation and Upgrade Guide—543573-001
2-13
Backup/Restore 2
the ZSPIDEF subvolume. This attempt results in a “duplicate file was found” error
during the DSM/SCM installation of T8472H01^ACW or later.
You can avoid this problem by manually removing T0063 before the upgrade, as
follows: During the upgrade operation, DSM/SCM detects the duplicate SMF
components and generates a message indicating that T0063 is already present in your
current configuration. DSM/SCM then prompts you to either retain or remove it.
Respond to this prompt by requesting removal of T0063.
Backup/Restore 2
Products Merged Into Single T-Number
Beginning in the H06.05 RVU, the Backup/Restore 2 products are merged into a single
T-number, T0744. When you use DSM/SCM to install the new SUT, the following
screen will appear, prompting you to select the products to retain:
Since the new T-number T0744 is replacing the previous T27nn T-numbers, click
Continue without selecting any of the T27nn T-numbers. DSM/SCM will remove those
T-numbers from your configuration and install T0744.
Fallback SPR Required for OSS Large Files
If you are falling back to H06.05, install the Backup and Restore 2 SPR
T0744H01^AAA to restore files smaller than 2 GB. Files larger than 2 GB are skipped.
T0744H01^AAA does not support pre-H06.05 RVUs. For details on the new OSS large
files feature, see OSS Large Files on page 2-4
vst750.vsd