H06.09 Software Installation and Upgrade Guide

Running ZPHIRNM
H06.09 Software Installation and Upgrade Guide—544316-002
6-6
Steps for Running ZPHIRNM
Steps for Running ZPHIRNM
1. At a TACL prompt, enter this command from the DSM/SCM subvolume:
> RUN ZPHIRNM $vol.SYSnn
where:
•
$vol specifies the default current system load volume, usually $SYSTEM.
•
SYSnn specifies the subvolume to which you just applied software. The SYSnn
subvolume must match the activation SYSnn that you specified earlier during
the Build/Apply phase.
2. When asked if you want to use a log file with the session, enter Y.
3. When prompted, enter a file name for the log file:
6> run zphirnm $system.sys00
DSM/SCM Utility - ZPHIRNM - T6031H01 - (11NOV2004)
Copyright Hewlett Packard Development Company L.P. 1993-2004
Do you want to use a log file with this session? (Y/N): y
You may use any file for logging. If you request to use a disk
file that doesn't exist, it will be created as an edit file.
Please enter a filename: elist00
Log file is open, Zphirnm will now begin processing.
ZPHIRNM begins processing and provides status of its progress.
4. If necessary, you can compare the creation dates of the whatis file to the
whatis_old file to see if changes occurred:
a. Run the more command against the whatis file:
more /usr/share/man/whatis
b. After reviewing the displayed file, exit by entering the letter q at the percentage
(%) prompt.
c. Repeat Steps a. and b. for the whatis_old file.
Verify That ZPHIRNM Ran Successfully
1. Review the log file.
2. If ZPHIRNM did not run successfully, correct whatever problems occurred and run
it again.
Two types of error and warning messages are issued during the renaming process:
•
If a fatal error occurs, ZPHIRNM immediately issues an error message and
stops.