H06.09 Software Installation and Upgrade Guide

Loading the H06.09 RVU
H06.09 Software Installation and Upgrade Guide—544316-002
7-6
Completing the System Load (If Necessary)
7. If the system load fails, look for halt codes or messages displayed in the Detailed
box on System Startup dialog box. For recovery procedures, see the Processor
Halt Codes Manual or Operator Messages Manual.
Completing the System Load (If Necessary)
Loading the processors with the CIIN file is usually automatic. However, if the
operating system loaded successfully into processor 0 or processor 1, but the
commands in the CIIN file do not reload all remaining processors, use the RELOAD
TACL commands. You must be super ID (255,255) to load the processors.
1. From the system console, log on to the system as a super-group user (255,nnn)
and enter:
> RELOAD *, PRIME
2. To load an individual processor or processors, enter:
> RELOAD nn
where nn is the processor number of the processor you want to reload.
If the reload is initiated successfully, this message appears in a startup TACL
window on the system console screen:
PROCESSOR RELOAD: nn
For complete syntax, considerations, and examples of the TACL RELOAD
command, see the TACL Reference Manual.