H06.09 Software Installation and Upgrade Guide
Overview of Installing the H06.09 RVU
H06.09 Software Installation and Upgrade Guide—544316-002
1-9
Managing Microcode and Firmware for Integrity
NonStop NS-Series Servers
This example shows a CONFTEXT file for H06.09:
$TEMP CONFIGXX 2> type conftext
ALLPROCESSORS:
SYSTEM_PROCESSOR_TYPE NSE-A;
SYSTEM_VOLUME_SUBVOL $SYSTEM.SYS00;
SYSTEM_LIBRARY_CODE_FILES TANDEM^LIBRARY^CODE^FILES;
SYSTEM_PROCESS_CODE_FILES TANDEM^PROCESS^CODE^FILES;
SYSTEM_PROCESS_LIBRARY_FILES TANDEM^PROCESS^LIBRARY^FILES;
STANDARD_MICROCODE TANDEM^STANDARD^MICROCODE;
MICROCODE_FILES TANDEM^MICROCODE^FILES;
FILES_TO_COPY_TO_NEW_SYSTEM TANDEM^FILES^TO^COPY;
SYSTEM_IMPLICIT_INIT_FILES TANDEM^IMPLICIT^INIT^FILES;
SYSTEM_IMPLICIT_CORE_FILES TANDEM^IMPLICIT^CORE^FILES;
SYSTEM_IMPLICIT_FS_FILES TANDEM^IMPLICIT^FS^FILES;
SYSTEM_IMPLICIT_MCP_FILES TANDEM^IMPLICIT^MCP^FILES;
SYSTEM_IMPLICIT_ETC_FILES TANDEM^IMPLICIT^ETC^FILES;
FORMATTER_TEMPLATE_FILES TANDEM^FORMATTER^TEMPLATE^FILES;
INITIAL_COMINT_INFILE $DSMSCM.SYS.CIIN;
tape_label_processing enabled;
Managing Microcode and Firmware for
Integrity NonStop NS-Series Servers
You must manage all microcode and firmware within your system properly, updating it
as necessary when new versions become available. Failure to do so can result in a
wide range of system problems, from intermittent faults to partial or complete system
outages.
OSM displays firmware version information, including file names and a Compare State
attribute, which compares the current version against the default or available version.
Outside of OSM, you can use the FILEINFO command to see firmware files.
Note. Trained HP service providers will update the firmware when they install any field-
replaceable units (FRUs). Firmware, unless otherwise noted, is considered customer-
updateable.
Note. Always check Scout for the most recent updateable firmware.
Although OSM does display firmware revision information (Downrev, Same, or Uprev), you can
enter the FILEINFO command to see firmware files using the FILEINFO command.
Enter this FILEINFO command, if you are connected to a NonStop S-series server, to check for
location and file information for CPUCODE and SPCODE:
$SYSTEM STARTUP 7
> FILEINFO $SYSTEM.SYS*.*CODE*
Enter this FILEINFO command check for location and file information for the HSS firmware:
$SYSTEM STARTUP 7
> FILEINFO $SYSTEM.SYS*.*FIRM*
Enter this FILEINFO command check for location and file information for other firmware, such
as ServerNet Clustering:
$SYSTEM STARTUP 7> FI SYS??.M????