H06.09 Software Installation and Upgrade Guide

H06.09 Installation, Migration, and Fallback
Considerations
H06.09 Software Installation and Upgrade Guide—544316-002
2-8
OSS Database Files
FUP PURGE MYFILE
FUP RENAME TEMP, MYFILE
•
Protect the program by creating a Format 1 file, then appending the desired data to
the file. For example, replace the command:
cp myfile /G/mydisk/mysubvol/myfile
with the commands:
gtacl -c ’FUP CREATE $mydisk.mysubvol.myfile, FORMAT 1, &
TYPE U, ODDUNSTR, CODE 180, EXT (28,1400), MAXTENTS 749’
cat myfile >> /G/mydisk/mysubvol/myfile
OSS Database Files
See the Open System Services Management and Operations Guide and the Open
System Services Installation Guide for information about updating and maintaining
OSS database files. See the Interactive Upgrade Guide 2 for new OSS features and
for a summary of migration or installation issues.
OSS Version 1 Filesets Not Supported
As of the H06.08 RVU, Version 1 filesets are not supported. You must upgrade
Version1 to Version 2 or Version 3 filesets.
The H06.08 RVU adds support for Access Control Lists (ACLs) for OSS regular files,
directories, first-in/first-out (FIFO) special files, and bound AF_UNIX sockets in OSS
Version 3 filesets. To use OSS ACLs, you must first migrate to the H06.08 or later
RVU, then migrate your existing filesets to Version 3 filesets. To migrate filesets, you
must stop the OSS filesystem and the OSS environment and use the
fsck DIAGNOSE FILESET, UPGRADE command as described in the Open System
Services Management and Operations Guide.
To restore backup tapes from H06.08 and later RVUs onto H06.05 through H06.07
RVUs, you must install the T0744 Backup/Restore 2 SPR. No T0744 Backup/Restore
2 SPR is available for pre-H06.05 RVUs.
Migration
If you migrate from the H06.04 RVU, HP strongly recommends that you install DP2
fallback SPR T9053H02^AQM before installing the H06.09 RVU, in case a fallback
becomes necessary. The DP2 fallback SPR is included on H06.05 and later SUTs.
Fallback
To fall back, you must install the previous SPRs for the OSS products and for DP2. In
addition, in either of these cases, you must run fsck on the fileset to downgrade the
fileset to Version 2: