H06.09 Software Installation and Upgrade Guide

H06.09 Software Installation and Upgrade Guide—544316-002
3-1
3 Upgrade Checklist
Use the checklist in Table 3-1 as you perform the tasks required to upgrade to the
H06.09 RVU and the checklist in Table 3-2 on page 3-3 to record the information
needed when performing these tasks. Table 3-3 on page 3-4 lists SPRs that should be
installed before upgrading to H06.09.
You might have to update the service processor (SP) firmware on NonStop S-series
systems for IOMF2 PMF customer-replaceable units (CRUs).
H06.09 Upgrade Checklist
Note. Minimum duration for tasks is not documented for H06.09.
Table 3-1. H06.09 Upgrade Checklist (page 1 of 3)
Task Description Reference Done?
1. Install the DSM/SCM client and server PVU (if
necessary).
Update DSM/SCM EMS template files (if
necessary).
Appendix B, Installing
SWID, DSM/SCM
PVU, and Planner
Interface (PI) Client
Software
2. Save current system configuration file. Save the Current
Configuration File
(CONFxxyy) on
page 4-3
3. Install required or recommended fallback SPRs
(if necessary).
Table 3-3
on page 3-4
Appendix A, Using
DSM/SCM to Install
SPRs
4. Upgrade system console software. Updating System
Consoles
(Optional)S7X-
SWV1/HNSC-SWV1,
Update 12 on page 1-3
5. Verify system operations. Verify System
Processes on page 4-3
6. Receive H06.09 SUT into the DSM/SCM
software archive.
Receive New Software
Into the Archive on
page 5-2
7. Create H06.09 software configuration revision. Create a New Software
Revision on page 5-6
8. Build and apply H06.09 software revision. Build and Apply the
New Software Revision
on page 5-11