H06.10 Software Installation and Upgrade Guide

phiwsock 1089/tcp #DSM/SCM Planner Interface
For DSM/SCM, the port number is user-definable. The setup default is 1089. In the ZDSMSCM
subvolume, check the INITSTAT file for the recently configured TCP/IP port number. INITSTAT
is created by DSM/SCM when INITENV is run.
Configure OSS
See the Open System Services Management and Operations Guide and the Open System Services
Installation Guide for information about updating and maintaining OSS database files.
See the Open System Services Management and Operations Guide and the Open System Services
Installation Guide for information about updating and maintaining OSS database files. See the
IUG for new OSS features and for a summary of migration or installation issues.
Install Specific OSS Files Using COPYOSS or PINSTALL
For those products that are not managed by DSM/SCM, you must install them using COPYOSS
or PINSTALL or both.
• If any OSS files are managed by DSM/SCM, use PINSTALL on the remaining pax archives.
See the OSS Management and Operations Guide for a description of PINSTALL use or the
pinstall(1) reference page in the OSS Shell and Utilities Reference Manual.
• If no OSS files are managed by DSM/SCM, use COPYOSS for all of the OSS pax archives in
the ZOSSUTL subvolume. See the OSS Management and Operations Guide for a description
of COPYOSS use or the copyoss(8) reference page in the OSS Shell and Utilities Reference
Manual. Then use PINSTALL to install any pax archives in other subvolumes. See the OSS
Management and Operations Guide for a description of PINSTALL use, or the pinstall(1)
reference page in the OSS Shell and Utilities Reference Manual.
See also the appropriate product’s softdoc for any pre- or post installation instructions.
Run the inetd Process
Run the inetd process immediately after loading the OSS product files into the OSS environment.
The inetd process listens for connections on certain Internet sockets. When a connection is
found on one of its sockets, inetd determines what service the socket corresponds to and invokes
a program to service the request.
For those products that are not managed by DSM/SCM, you must install them using COPYOSS
or PINSTALL. See the appropriate product’s softdoc and installation instructions.
Using OSS Unautomated Configuration and Startup
Unautomated configuration and startup is described in Appendix B in the Open System Services
Management and Operations Guide.
Using OSS EasySetup (T0585)
The OSS EasySetup product (T0585) is available for automated setup, as described in the Open
System Services Installation Guide. OSS EasySetup is a series of TACL scripts that assist a site when
configuring and installing a minimal OSS subsystem for the first time or when starting, stopping,
or removing an OSS subsystem.
Configure Specific Products (Post-System Load) 105