H06.10 Software Installation and Upgrade Guide

4> scf names adapter $zzwan.#*
SCF - T9082G02 - (16OCT98) (25SEP98) - 09/08/1999 15:53:26 System \ELI
Copyright Tandem Computers Incorporated 1986 - 1998
WANMgr Names ADAPTER $ZZWAN.#*
ADAPTER
$ZZWAN.#S00
$ZZWAN.#S01
To Check Location and Version of New SWAN CLIP Firmware
At a TACL prompt, enter the VPROC command:
TACL>VPROC $SYSTEM.CSSnn.C7953P00
where nn is the number specified during the Build/Apply phase of installing the H06.03 RVU:
• Use the SCF STATUS SERVER $ZZWAN.#conc-name.clip-num, DETAIL command. For
example:
$SYSTEM ZWANTOOL 14> scf status server $zzwan.#s01.3, detail
• Or, use the WANLNCK utility (part of the SWAN Tools product placed in the ZWANTOOL
subvolume in H-series RVUs). A DEVICE must be configured and in the STARTED state
on the CLIP for this purpose. For example:
$SYSTEM ZWANTOOL 12> run wanlnck line $x25131,diag $system.css04.d8155p00
.
.
VPROC from CLIP: T7954G01^21OCT99^AAF^R002
.
.
To Stop the CLIPs
Use the SCF STOP ADAPTER command:
5> SCF STOP ADAPTER $ZZWAN.#S01, SUB ALL
To Verify That CLIPs Are Stopped
Use the SCF STATUS SERVER command:
2-> status server $zzwan.#s01.*
WAN Manager STATUS SERVER for CLIP \ELI.$ZZWAN.#S01.1
State :......... STOPPED
.
.
WAN Manager STATUS SERVER for CLIP \ELI.$ZZWAN.#S01.2
State :......... STOPPED
.
.
WAN Manager STATUS SERVER for CLIP \ELI.$ZZWAN.#S01.3
State :......... STOPPED
.
.
To Point SWAN Concentrators to the New Firmware Object Code File
Use the SCF ALTER ADAPTER, KERNELCODE command:
Using SCF Commands to Aid in Updating SWAN CLIP Firmware 149