H06.11 Software Installation and Upgrade Guide

where nn is the processor number of the processor you want to reload.
If the reload is initiated successfully, this message appears in a startup TACL window on
the system console screen:
Install Specific OSS Files (If Necessary)
For those products that are not managed by DSM/SCM, you must install them using COPYOSS
or PINSTALL or both. For details, see “Install Specific OSS Files Using COPYOSS or PINSTALL”
(page 107).
Verifying the System Is Started
Verify that each processor is running the operating system:
1. From the Summary menu, select Processor Status.
2. The Processor Status dialog box should show each processor to be Executing NonStop OS.
Reverting to Previous NonStop Blade Complex Firmware
This section shows procedures for reverting from your installed RVU to a previous RVU. There
are three procedures. The correct procedure depends on which RVU is currently installed and
on which RVU you are reverting to. Use the following table to determine the correct procedure
to use:
Installed RVU
Fallback RVU
H06.11.03H06.11.02H06.11.01H06.11.00
“Procedure 1”“Procedure 1”“Procedure 1”“Procedure 1”H06.03
“Procedure 1”“Procedure 1”“Procedure 1”“Procedure 1”H06.04
“Procedure 2”“Procedure 2”“Procedure 3”“Procedure 2”H06.05
“Procedure 2”“Procedure 2”“Procedure 3”“Procedure 2”H06.06
“Procedure 2”“Procedure 2”“Procedure 3”“Procedure 2”H06.07
“Procedure 2”“Procedure 2”“Procedure 3”“Procedure 2”H06.08
“Procedure 2”“Procedure 2”“Procedure 2”“Procedure 2”H06.09
“Procedure 2”“Procedure 2”“Procedure 2”“Procedure 2”H06.10
“Procedure 2”“Procedure 2”“Procedure 2”—H06.11.00
—“Procedure 2”——H06.11.01
Reverting to Previous NonStop Blade Complex Firmware 119