H06.11 Software Installation and Upgrade Guide

c. Reset the NonStop Blade Elements one at a time. Wait for each NonStop Blade Element
to be reintegrated before proceeding. Use the OSM Service Connection Blade Element
Reset Action to reset the NonStop Blade Element.
NOTE: Note: HP recommends that you reset and reintegrate each NonStop Blade
Element one at a time. (The Reset action power cycles the NonStop Blade Element.)
Resetting all NonStop Blade Elements at the same time will take four processors offline.
Do not manually power cycle the processors. Doing so will leave the NonStop Blade
Elements and NonStop Blade Complex in an incomplete state.
The shadow firmware image that has been updated is now the running flash image.
The previous running image is now the shadow image.
d. Repeat steps a. through c. to update the new shadow image on all NonStop Blade
Elements or one NonStop Blade Element at a time until all the NonStop Blade Elements
are done.
e. Repeat steps a. through d. for the other NonStop Blade Complexes.
Managing ServerNet Adapter Firmware
This manual covers only the ServerNet adapters supported in I/O adapter modules (IOAMS):
• Fibre Channel ServerNet adapter (FCSA)
• Gigabit Ethernet 4-port ServerNet adapter (G4SA)
To update firmware for ServerNet adapters connected to legacy IOMF2 CRUs, see the latest
G-series Software Installation and Upgrade Guide.
34 Overview of Installing the H06.11 RVU