H06.11 Software Installation and Upgrade Guide

Before Starting DSM/SCM.............................................................................................................138
Start DSM/SCM..............................................................................................................................139
Verify That the H02 PVU of DSM/SCM Is Installed......................................................................139
Verify That SWID Is Installed........................................................................................................140
Recovery for Problems While Installing the H02 Version of DSM/SCM ...........................................140
If NonStop Errors Are Displayed..................................................................................................140
Cancel Pending Build/Apply Requests....................................................................................140
Install the DSM/SCM Client From ZDSMSCM ..................................................................................141
Alert (DSM/SCM T6031G02/H02 Client).......................................................................................141
Determine Your DSM/SCM Client Software Version....................................................................141
Determine the Current IP Address and Port Number..................................................................141
Copy the ZDSMSCM Client File From the Host...........................................................................142
Install the DSM/SCM Client Software...........................................................................................143
Create an Emergency Repair Disk (ERD) or Automated System Recovery (ASR) Disk ..............147
C Updating SWAN Concentrator CLIP Firmware......................................................149
Using the OSM Multi-Resource Actions Dialog to Update SWAN and SWAN 2 Firmware.............149
Step 1: Stop the SWAN Concentrator and CLIPs..........................................................................149
Step 2: Check the Location and Version of the SWAN Firmware..................................................150
Step 3: Initiate the Firmware Update.............................................................................................151
Step 4: Start the SWAN Concentrator and CLIPs..........................................................................152
If a CLIP Fails to Update, Use the OSM Actions Dialog Box .............................................................152
Using SCF Commands to Aid in Updating SWAN CLIP Firmware..................................................152
To List the Names of the SWAN Concentrators and CLIPs..........................................................152
To Check Location and Version of New SWAN CLIP Firmware..................................................153
To Stop the CLIPs...........................................................................................................................153
To Verify That CLIPs Are Stopped...........................................................................................153
To Point SWAN Concentrators to the New Firmware Object Code File.......................................153
To Start the SWAN Concentrator and CLIPs.................................................................................154
To Verify That the SWAN CLIPs Are Running the Latest Firmware............................................154
To Start Stopped Lines ..................................................................................................................154
Glossary.........................................................................................................................155
Index...............................................................................................................................159
8 Table of Contents