H06.12 Software Installation and Upgrade Guide

SYSTEM STARTUP COMPLETE,
NSK RUNNING ON PROCESSOR n
7. If the system load fails, look for halt codes or messages displayed in the Detailed box on
System Startup dialog box. For recovery procedures, see the Processor Halt Codes Manual or
Operator Messages Manual.
Completing the System Load (If Necessary)
Loading the processors with the CIIN file is usually automatic. However, if the operating system
loaded successfully into processor 0 or processor 1, but the commands in the CIIN file do not
reload all remaining processors, use the RELOAD TACL commands. You must be super ID
(255,255) to load the processors.
1. From the system console, log on to the system as a super-group user (255,nnn) and enter:
> RELOAD *, PRIME
2. To load an individual processor or processors, enter:
> RELOAD nn
where nn is the processor number of the processor you want to reload.
If the reload is initiated successfully, this message appears in a startup TACL window on
the system console screen:
PROCESSOR RELOAD: nn
For complete syntax, considerations, and examples of the TACL RELOAD command, see
the TACL Reference Manual.
Verifying That the System Is Started
Verify that each processor is running the operating system:
1. Select Summary>Processor Status.
The Processor Status dialog box should show each processor to be Executing NonStop OS.
Loading the System 101