H06.12 Software Installation and Upgrade Guide

B Installing SWID, DSM/SCM PVU, and Planner Interface
(PI) Client Software
NOTE:
• For Integrity NonStop NS-series servers, you must have installed both the DSM/SCM SPR and the corresponding
client version before you receive an RVU SUT. For H06.12, all newly shipped Integrity NonStop NS-series servers
will have the latest DSM/SCM SPR installed. The latest DSM/SCM client version is available only on the SUT
unless you have ordered new system consoles.
• Always install the latest SWID PVU at the same time you install a new DSM/SCM PVU to avoid a fingerprint or
mismatched file problem. (DSM/SCM uses SWID to determine if a file has changed by a method called
fingerprinting. If an existing file has a different fingerprint from a newer file, the newer version replaces the
existing file.) For H06.12, your newly shipped Integrity NonStop NS-series server will have the latest SWID SPR.
Alerts
• “Determine the Product Version of DSM/SCM on the Host System” and “Determine the
Product Version of DSM/SCM on the Client”.
• Save the current configuration database. (See “Save the Current Configuration File
(CONFxxyy)” (page 66)).
• Keep the startup TACL windows, the EMS Event Stream window, and the DSM/SCM client
interface windows open whenever you are performing a Build/Apply. Otherwise,
Build/Apply errors will result.
• If you receive an error indication in the Request Status window, you might have to reinitiate
the Build/Apply. See the DSM/SCM Messages Manual to learn the nature and severity of the
problem.
Determine the Product Version of DSM/SCM on the Host System
To determine which product version of DSM/SCM is currently installed on your system, use the
VPROC command to determine the product version of TAEXE (Apply product of DSM/SCM)
and CBEXE (Build product of DSM/SCM).
At a TACL prompt, enter:
> volume $dsmscm_vol.ZDSMSCM
> vproc taexe
> vproc cbexe
If your VPROC commands do not display the following versions, install the latest H02 DSM/SCM
product version as described in “Copy (RESTORE) the H02 DSM/SCM Product Version to Disk
(If Necessary)” (page 133):
This example shows the ABQ product version update of DSM/SCM after DSM/SCM has been
activated for H06.07. (Bold lettering is used to show the VPROC command and the latest version):
\DRP08.$DSMSCM.ZDSMSCM 2> vproc cbexe
VPROC - T9617H01 - (01 OCT 2004) SYSTEM \DRP08 Date 12 May 2006, 18:20:02
Copyright 2004 Hewlett-Packard Development Company, L.P.
$DSMSCM.ZDSMSCM.CBEXE
Binder timestamp: 17NOV2005 15:59:49
Version procedure: S7032H06^01OCT2004^SWARCCP^H01
Version procedure: T6031H02_01NOV2005_16DEC05ABQ
Target CPU: UNSPECIFIED
OCA timestamp: 16DEC2005 16:06:21
\DRP08.$DSMSCM.ZDSMSCM 3> vproc taexe
VPROC - T9617H01 - (01 OCT 2004) SYSTEM \DRP08 Date 12 MAY 2006, 18:20:13
Alerts 131