H06.12 Software Installation and Upgrade Guide

Start DSM/SCM..............................................................................................................................137
Verify That the H02 PVU of DSM/SCM Is Installed......................................................................137
Verify That SWID Is Installed........................................................................................................138
Recovery for Problems While Installing the H02 Version of DSM/SCM ...........................................138
If NonStop Errors Are Displayed..................................................................................................138
Cancel Pending Build/Apply Requests....................................................................................138
Install the DSM/SCM Client From ZDSMSCM ..................................................................................139
Alert (DSM/SCM T6031G02/H02 Client).......................................................................................139
Determine Your DSM/SCM Client Software Version....................................................................139
Determine the Current IP Address and Port Number..................................................................139
Copy the ZDSMSCM Client File From the Host...........................................................................140
Install the DSM/SCM Client Software...........................................................................................141
Create an Emergency Repair Disk (ERD) or Automated System Recovery (ASR) Disk ..............145
C Updating SWAN Concentrator CLIP Firmware......................................................147
Using the OSM Multi-Resource Actions Dialog to Update SWAN and SWAN 2 Firmware.............147
Step 1: Stop the SWAN Concentrator and CLIPs..........................................................................147
Step 2: Check the Location and Version of the SWAN Firmware..................................................148
Step 3: Initiate the Firmware Update.............................................................................................149
Step 4: Start the SWAN Concentrator and CLIPs..........................................................................150
If a CLIP Fails to Update, Use the OSM Actions Dialog Box .............................................................150
Using SCF Commands to Aid in Updating SWAN CLIP Firmware..................................................151
To List the Names of the SWAN Concentrators and CLIPs..........................................................151
To Check Location and Version of New SWAN CLIP Firmware..................................................151
To Stop the CLIPs...........................................................................................................................151
To Verify That CLIPs Are Stopped...........................................................................................151
To Point SWAN Concentrators to the New Firmware Object Code File.......................................152
To Start the SWAN Concentrator and CLIPs.................................................................................152
To Verify That the SWAN CLIPs Are Running the Latest Firmware............................................152
To Start Stopped Lines ..................................................................................................................152
Glossary.........................................................................................................................153
Index...............................................................................................................................157
8 Table of Contents