H06.13 Software Installation and Upgrade Guide

About This Document

This guide describes:

• Upgrading the initial H06.13 RVU through the use of site update tape (SUT) refreshes, if

necessary.

• Falling back to a previous SYSnn.

Supported Release Version Updates (RVUs)

This manual supports the H06.13.00 RVU and all subsequent H06.13.nn RVURs unless otherwise

noted. Exceptions are called out in the text.

Intended Audience

This guide is written for operations staff and support personnel and requires a working knowledge

of Windows XP Professional, Windows 2003 Server, HP NonStop Open System Management

(OSM) Interface client and server components, system console software, the Distributed Systems

Management/Software Configuration Manager (DSM/SCM) Planner Interface, Target Interface

(ZPHITI), and ZPHIRNM applications.

New and Changed Information in This Edition

This edition (544961-002) contains these changes:

• “Check or Alter the CONFTEXT File Before Installing an H06.13 SUT ” (page 21) is updated

to reference the J06.nn Software Installation and Update Guide for NonStop NS2000 systems.

• The former Managing Microcode and Firmware for NonStop NS-Series Servers section in

Chapter 1 has been moved into a separate “Managing Microcode and Firmware for NonStop

NS-Series Servers” (page 24) chapter (Chapter 2).

• “Managing SWAN and SWAN 2 Concentrator Firmware” (page 37) is updated to reference

either the SWAN Concentrator Installation and Support Guide or the SWAN 2 Concentrator

Installation and Support Guide.

• “H06.13” (page 57) has been added to Chapter 3.

• A note to prevent overwriting the original inetd.conf file has been added to “Run the inetd

Process” (page 101) in Chapter 9.

• “Configure the WAN Manager” (page 102) is updated to reference either the SWAN

Concentrator Installation and Support Guide or the SWAN 2 Concentrator Installation and

Support Guide.

• An obsolete procedure for creating a recovery CD (Create an Emergency Repair Disk (ERD)

or Automated System Recovery (ASR) Disk) has been deleted.

• “Updating SWAN Concentrator CLIP Firmware” (page 139) is updated to reference either the

SWAN Concentrator Installation and Support Guide or the SWAN 2 Concentrator Installation

and Support Guide.