H06.13 Software Installation and Upgrade Guide

4 Upgrade Checklist
Use the checklist in Table 11 as you perform the tasks required to upgrade to the H06.13 RVU
and the checklist in Table 12 (page 59) to record the information needed when performing these
tasks. Table 13 (page 60) lists SPRs that should be installed before upgrading to H06.13.
NOTE: Minimum duration for tasks is not documented for H06.13.
You might have to update the service processor (SP) firmware on NonStop S-series systems for
IOMF2 PMF customer-replaceable units (CRUs).
H06.13 Upgrade Checklist
Table 11 H06.13 Upgrade Checklist
Done?ReferenceTask Description
Appendix B: “ Installing SWID, DSM/SCM PVU, and
Planner Interface (PI) Client Software ”
1. Install the DSM/SCM client and
server PVU (if necessary).Update
DSM/SCM EMS template files (if
necessary)
“Save the Current Configuration File (CONFxxyy)”
(page 62)
2. Save current system configuration
file.
Table 13: “Recommended Fallback SPRs”
Appendix A: “Using DSM/SCM to Install SPRs”
3. Install required or recommended
fallback SPRs (if necessary).
“Updating System Consoles (Optional)
S7X-SWV2/HNSC-SWV2, Update 3” (page 16)
4. Upgrade system console software.
“Verify System Processes” (page 62)5. Verify system operations.
“Receive New Software Into the Archive” (page 70)6. Receive H06.13 SUT into the
DSM/SCM software archive.
“Create a New Software Revision” (page 74)7. Create H06.13 software
configuration revision.
“Build and Apply the New Software Revision” (page 77)8. Build and apply H06.13 software
revision.
“Print Operator Instructions From the Target Interface
(ZPHITI)” (page 82)
9. Print the DSM/SCM Operator
Instructions.
Chapter 7: “Running ZPHIRNM ”10. Run ZPHIRNM.
“Halt the Processors” (page 92)11. Halt processors.
“Loading the System” (page 93)12. Load the system with the new
H06.13 RVU.
“Managing Maintenance Entity (ME) Firmware and ME
FPGA Firmware” (page 24) and the CSSI web page
13. Update IOAM firmware (P-switch
firmware).
“Managing Firmware in a NonStop Blade Complex”
(page 27)
14. Update NonStop Blade Complex
(NSBC) firmware.
“Managing ServerNet Adapter Firmware” (page 33)15. Update G4SA Download Code
firmware
“Managing ServerNet Adapter Firmware” (page 33)16. Install ISP1040 firmware
“Managing ServerNet Adapter Firmware” (page 33)17. Update FCSA F/W firmware
“Update NonStop TCP/IP Configuration Files” (page 99)18. Recover the TCP/IP files (if
necessary).
58 Upgrade Checklist