H06.14 Software Installation and Upgrade Guide

8. Enter the IP port number for the Winsock service (see “Determine the Current IP Address and
Port Number” (page 133)), and click Next.
NOTE: If DSM/SCM is not currently configured to communicate with a host system, accept
the default IP port number. You can always change this value later by editing the dsmscm.ini
file.
You are now prompted to enter the host system name.
9. Enter the host system name (or \noname if DSM/SCM is not currently configured to
communicate with a host system), and click Next to continue.
You are asked if you would like to run DSM/SCM.
138 Installing SWID, DSM/SCM PVU, and Planner Interface (PI) Client Software