H06.14 Software Installation and Upgrade Guide

8 Loading the H06.14 RVU
This chapter describes how to perform a system load of the H06.14 RVU into the memory of each
processor in a NonStop NS-series server.
NOTE: For detailed information on performing a system load of a NonStop NS-series server,
see Chapter 15 in the NonStop Operations Guide.
By default, one $SYSTEM is already configured. You can select $SYSTEM, FCDM-Load, SCSI-Load,
or an alternate system volume:
• A load from $SYSTEM attempts to load the system from a disk in group, module, slot 11.1.11
of a NonStop S-series I/O enclosure, by default. The $SYSTEM disks must contain the current
RVU operating system files for the NonStop NS-series system. Table 17 shows the possible
load paths in order of use:
Table 17 System Load Paths in Order of Use
Data Travels
Over ServerNet FabricTo ProcessorFromDescriptionLoad Path
X0$SYSTEM-PPrimary1
Y0$SYSTEM-PPrimary2
X0$SYSTEM-PBackup3
Y0$SYSTEM-PBackup4
X0$SYSTEM-MMirror5
Y0$SYSTEM-MMirror6
X0$SYSTEM-MMirror backup7
Y0$SYSTEM-MMirror backup8
X1$SYSTEM-PPrimary9
Y1$SYSTEM-PPrimary10
X1$SYSTEM-PBackup11
Y1$SYSTEM-PBackup12
X1$SYSTEM-MMirror13
Y1$SYSTEM-MMirror14
X1$SYSTEM-MMirror backup15
Y1$SYSTEM-MMirror backup16
• An FCDM-Load attempts to load the system from a system disk in the disk drive enclosure
connected to IOAM enclosure group 110:
Disk Drive
Enclosure
FCSAIOAM
BayShelfSACSlotModuleGroupPath
11112110Primary
11113110Backup
92 Loading the H06.14 RVU