H06.15 Software Installation and Upgrade Guide

$Z03N: TCP TCP-T, STARTED
2. If necessary, press Enter to have STARTSCM run the IPM6031 TACL macro automatically. This
step takes several minutes.
STARTSCM: A new version of DSM/SCM has been installed and IPM6031
needs to be run. You can either exit and run IPM6031
manually or continue and IPM6031 will be run for you.
Enter <CR> to continue or BREAK to exit.
Verify that the Latest SPR of DSM/SCM is Installed
To determine which product version of DSM/SCM is currently installed on your system, use the
VPROC command to determine the product version of TAEXE (Apply product of DSM/SCM) and
CBEXE (Build product of DSM/SCM).
At a TACL prompt, enter:
> volume $dsmscm_vol.ZDSMSCM
> vproc taexe
> vproc cbexe
If your VPROC commands do not display the version for this RVU, install the correct H02 DSM/SCM
product version by following the procedures in “Copy (RESTORE) the H02 DSM/SCM Product
Version to Disk (If Necessary)” (page 147).
The DSM/SCM version for this RVU is ACI.
Verify That SWID Is Installed
Verify that you have the correct version of SWID by using the VPROC command: vproc swid.
The SWID version for this RVU is AAS.
Recovery for Problems While Installing the H02 Version of DSM/SCM
If you encounter problems while installing the H02 version of DSM/SCM, see the DSM/SCM
User’s Guide.
If NonStop Errors Are Displayed
See the DSM/SCM Messages manual for information regarding the error message and the
DSM/SCM User’s Guide for information on deleting a Build/Apply request.
Cancel Pending Build/Apply Requests
NOTE: If you inadvertently close the Status page, reopen it by clicking on the Request Name link
on the Request List page.
Click the Cancel button.
The cancel request action takes a few minutes to finish.
NOTE: If you cannot cancel the Build request through NonStop Software Essentials, use the
DSM/SCM Target Interface (ZPHITI) to cancel the request. See the online help for more information.
Install the NonStop Software Essentials Client
NOTE: See the NonStop Software Essentials Installation and Quick Start Guide.
NonStop Software Essentials requires DSM/SCM version ACS or later. However, the DSM/SCM
version for this RVU (ACI) provides all the functionality needed for NonStop Software Essentials to
perform the installation and upgrade tasks in this guide.
Recovery for Problems While Installing the H02 Version of DSM/SCM 151