H06.16 Software Installation and Upgrade Guide

Files Processed:
Files processed in new configuration ........................... 4038
Files processed in new configuration only ...................... 0
Files processed in old configuration only ...................... 9
Files processed that are shared by new and old configuration ... 4038
Files processed & unchanged between new and old configuration .. 4038
Files processed in obsolete TSVs ............................... 14
Files renamed from real name to fabricated name ................ 23
Files renamed from fabricated name to real name ................ 0
Files renamed from real name to fabricated (ZPG) name .......... 0
Files renamed from fabricated name to fabricated (ZPG) name .... 0
-------
Total Number of files renamed .................................. 23
Number of files renamed back during undo processing ............ 0
Generic Process MODification(ZMODGP) is not required because no ZcccGP files
in the $SYSTEM.ZCNFDEFS TSV have changed.
Process Time:
Start ....... 1/29/05 16:43:20
End ......... 1/29/05 16:43:37
Elapsed ..... 0:00:16
Errors & Warnings:
Total Rename Errors ..... 0
Total Rename Warnings ... 0
ZPHIRNM for $SYSTEM($DRP07).SYS04 finished successfully
PREVIEW mode also reveals most errors that ZPHIRNM would encounter if it were run. If errors
are revealed, you can evaluate and correct them interactively.
The syntax for running ZPHIRNM in PREVIEW mode is (from the DSM/SCM subvolume):
> RUN ZPHIRNM [$vol.]SYSnn , PREVIEW [STRICT] [,option] ...
If you enter a RUN ZPHIRNM command with no arguments, ZPHIRNM help text displays information
about PREVIEW mode. For more information, see the DSM/SCM User's Guide.
Steps for Running ZPHIRNM
1. At a TACL prompt, enter this command from the DSM/SCM subvolume:
> RUN ZPHIRNM $vol.SYSnn
where:
• $vol specifies the default current system load volume, usually $SYSTEM.
• SYSnn specifies the subvolume to which you just applied software. The SYSnn subvolume
must match the activation SYSnn that you specified earlier during the Build/Apply phase.
2. When asked if you want to use a log file with the session, enter Y.
3. When prompted, enter a file name for the log file:
6> run zphirnm $system.sys00
DSM/SCM Utility - ZPHIRNM - T6031H01 - (11NOV2004)
Copyright Hewlett Packard Development Company L.P. 1993-2004
ZPHIRNM 103