H06.16 Software Installation and Upgrade Guide

Table 8 Upgrade Checklist (continued)
Done?ReferenceTask Description
“Receive New Software Into the Archive” (page 85)8. For those with DSM/SCM Planner
Interface, receive this RVU SUT into
DSM/SCM software archive.
“Create a New Software Revision” (page 75)9. For those with NonStop Software
Essentials, create this RVU software
configuration revision.
“Create a New Software Revision” (page 89)10. For those with DSM/SCM Planner
Interface, create this RVU software
configuration revision.
“Build and Apply the New Software Revision” (page 78)11. For those with NonStop Software
Essentials, build and apply this RVU
software revision.
“Build and Apply the New Software Revision” (page 92)12. For those with DSM/SCM Planner
Interface, build and apply this RVU
software revision.
“Print Operator Instructions From the Target Interface
(ZPHITI)” (page 96)
13. Print DSM/SCM Operator
Instructions.
Chapter 8: “Running ZPHIRNM ”14. Run ZPHIRNM.
“2. Halt the Processors” (page 108)15. Halt processors.
Cluster I/O Protocols (CIP) Configuration and
Management Manual
16. If CLIMs are present, update CLIM
software on all CLIMs using the
procedure “Performing the CLIM
Software Upgrade Using OSM
Low-Level Link.” (If you are migrating
from H06.17 or a later RVU and
performed an online upgrade of the
CLIM to the CLIM software released
with this RVU before starting the host
system upgrade, you can skip this
step.)
“6. Loading the System” (page 108)17. Load system with this new RVU.
“Managing Maintenance Entity (ME) Firmware and ME
FPGA Firmware” (page 24) and the CSSI web page
18. Update ME and ME FPGA
firmware, if necessary.
“Managing NonStop Blade Complex Firmware”
(page 27)
19. Update NonStop Blade Complex
(NSBC) firmware.
“Managing ServerNet Adapter Firmware” (page 31)20. Update G4SA Download Code
firmware, if necessary.
“Managing ServerNet Adapter Firmware” (page 31)21. Install ISP1040 firmware, if
necessary.
“Managing ServerNet Adapter Firmware” (page 31)22. Update FCSA firmware, if
necessary.
“Managing CLIM Firmware” (page 34)23. As needed, update firmware for
CLIM components.
“Update NonStop TCP/IP Configuration Files” (page 116)24. Recover the TCP/IP files, if
necessary.
“Check Processor Status ” (page 63)25. Check processor status.
“Configure the WAN Manager” (page 119)26. Configure WANMGR, if
necessary.
Upgrade Checklist 59