H06.17 Software Installation and Upgrade Guide
• Duplicate information has been removed from “Installation, Migration, and Fallback
Considerations” (page 36).
• “DSM Tape Catalog Migration” (page 54) has been added to “H06.13” (page 54) in Chapter
3.
• “CLuster I/O Module (CLIM)” (page 57) has been added to “H06.16” (page 55) in Chapter
3.
• A note to prevent overwriting the original inetd.conf file has been added.
• “Configure the WAN Manager” (page 121) is updated to reference either the SWAN
Concentrator Installation and Support Guide or the SWAN 2 Concentrator Installation and
Support Guide.
• The Create an Emergency Repair Disk (ERD) or Automated System Recovery (ASR) Disk section
has been deleted.
• “Updating SWAN Concentrator CLIP Firmware” (page 194) is updated to reference either the
SWAN Concentrator Installation and Support Guide or the SWAN 2 Concentrator Installation
and Support Guide.
The 518661-005 edition contained these changes:
• The NSK State attribute field referred to in the screen shot in “Check System Components ”
(page 65) was changed to Logical Processor State.
• A caution and steps to ensure you have a backup of $SYSTEM before applying the new RVU
have been added to:
◦ “Back Up System Information” (page 73).
◦ “Build and Apply the New Software Revision” (page 94).
◦ Chapter 10 (page 116). See “Revive the Down Half of the Mirrored Disk” (page 116).
• This alert If you do not select a $SYSTEM volume, you must revive the mirrored disk was
removed from Chapter 9 (page 107).
• A missing figure was corrected in “Steps for Loading the System” (page 111).
• A clarification has been made to the CLIM restore procedure.
The 518661-004 edition contained these changes:
• An additional step in the procedure for falling back on the CLIMs
• Current HSS firmware SPR level changed from T8004 AAJ to T8004 AAI
• Correction to T0287 file name
What This Guide Does Not Cover
• System migration planning. System-wide issues involved in migrating to the latest H-series RVU
are covered in:
◦ The H06.nn Release Version Update Compendium for this RVU
◦ The Interactive Upgrade Guide 2 (IUG2)
• Installing an H-series RVU from a host system to a remote or separate network-connected target
system using an Expand connection or tape. See the DSM/SCM User's Guide for information
on setting up target systems.
• Installing and configuring HP NonStop Open System Services (OSS).
12