H06.17 Software Installation and Upgrade Guide

Table 8 Upgrade Checklist (continued)
Done?ReferenceTask Description
“Receive New Software Into the Archive” (page 87)8. For those with DSM/SCM Planner
Interface, receive this RVU SUT into
DSM/SCM software archive.
“Create a New Software Revision” (page 77)9. For those with NonStop Software
Essentials, create this RVU software
configuration revision.
“Create a New Software Revision” (page 91)10. For those with DSM/SCM Planner
Interface, create this RVU software
configuration revision.
“Build and Apply the New Software Revision” (page 80)11. For those with NonStop Software
Essentials, build and apply this RVU
software revision.
“Build and Apply the New Software Revision” (page 94)12. For those with DSM/SCM Planner
Interface, build and apply this RVU
software revision.
“Print Operator Instructions From the Target Interface
(ZPHITI)” (page 98)
13. Print DSM/SCM Operator
Instructions.
Chapter 8: “Running ZPHIRNM ”14. Run ZPHIRNM.
“2. Halt the Processors” (page 110)15. Halt processors.
Cluster I/O Protocols (CIP) Configuration and
Management Manual
16. If CLIMs are present, update CLIM
software on all CLIMs using the
procedure “Performing the CLIM
Software Upgrade Using OSM
Low-Level Link.” (If you are migrating
from H06.17 or a later RVU and
performed an online upgrade of the
CLIM to the CLIM software released
with this RVU before starting the host
system upgrade, you can skip this
step.)
“6. Loading the System” (page 110)17. Load system with this new RVU.
“Managing Maintenance Entity (ME) Firmware and ME
FPGA Firmware” (page 25) and the CSSI web page
18. Update ME and ME FPGA
firmware, if necessary.
“Managing NonStop Blade Complex Firmware”
(page 28)
19. Update NonStop Blade Complex
(NSBC) firmware.
“Managing ServerNet Adapter Firmware” (page 32)20. Update G4SA Download Code
firmware, if necessary.
“Managing ServerNet Adapter Firmware” (page 32)21. Install ISP1040 firmware, if
necessary.
“Managing ServerNet Adapter Firmware” (page 32)22. Update FCSA firmware, if
necessary.
“Managing CLIM Firmware” (page 35)23. As needed, update firmware for
CLIM components.
“Update NonStop TCP/IP Configuration Files” (page 118)24. Recover the TCP/IP files, if
necessary.
“Check Processor Status ” (page 65)25. Check processor status.
“Configure the WAN Manager” (page 121)26. Configure WANMGR, if
necessary.
Upgrade Checklist 61