H06.18 Software Installation and Upgrade Guide

The 538127-004 edition contained these changes and additions:

• “Check or Alter the CONFTEXT File Before Installing This RVU SUT ” (page 23) is updated to

reference the J06.nn Software Installation and Update Guide for NonStop NS2000 systems.

• “Managing SWAN and SWAN 2 Concentrator Firmware” (page 36) is updated to reference

either the SWAN Concentrator Installation and Support Guide or the SWAN 2 Concentrator

Installation and Support Guide.

• Duplicate information has been removed from “Installation, Migration, and Fallback

Considerations” (page 38).

• “DSM Tape Catalog Migration” (page 56) has been added to “H06.13” (page 56) in Chapter

• “CLuster I/O Module (CLIM)” (page 59) has been added to “H06.16” (page 57) in Chapter

• “DSM/SCM Upgrade Issues/Interoperability SPR Requirements” (page 60) has been added

to “H06.18” (page 60) in Chapter 3.

• A note to prevent overwriting the original inetd.conf file has been added in Chapter 9.

• “Configure the WAN Manager” (page 123) is updated to reference either the SWAN

Concentrator Installation and Support Guide or the SWAN 2 Concentrator Installation and

Support Guide.

• “Complete CLIM Setup” (page 154) is updated for falling back to the previous RVU.

• The Create an Emergency Repair Disk (ERD) or Automated System Recovery (ASR) Disk section

has been deleted.

• “Updating SWAN Concentrator CLIP Firmware” (page 193) is updated to reference either the

SWAN Concentrator Installation and Support Guide or the SWAN 2 Concentrator Installation

and Support Guide.

The 538127-003 edition contained these changes:

• References to the NonStop Firmware Matrices document for non-SUT based firmware have

been added to Chapter 2 (page 26).

• A correction was made to “Complete CLIM Setup” (page 154). You must be logged onto the

NonStop host system as SUPER.SUPER, not just a SUPER group user, to run SSOCLIM.

The 538127-002 edition contained these changes:

• The addition of Scout for NonStop Servers as a source for some CLuster I/O Module (CLIM)

software Software product revisions (SPRs).

• A clarification to “AF_UNIX Release 2 Migration and Fallback” (page 57).

• The addition of a caution and steps to ensure you have a backup of $SYSTEM before applying

the new RVU

• The removal of this alert: If you do not select a $SYSTEM volume, you must revive the mirrored

disk in Chapter 9: “Loading This RVU”.

• The addition of screen shots for the CLIM re-image procedure.

• A clarification to the CLIM restore procedure.