H06.18 Software Installation and Upgrade Guide

If the reload is initiated successfully, this message appears in a startup TACL window on the
system console screen:
PROCESSOR RELOAD: nn
If Falling Back to the H06.03 or H06.04 RVU
If you are falling back to the H06.03 or H06.04 RVU, then after loading the previous RVU, finish
loading the rest of the NonStop Blade Complex firmware, as described in step 6c under “Reverting
to H06.03 or H06.04 From This RVU” (page 155).
Complete CLIM Setup
1. Establish trust between the CLIM and the NonStop host system.
Run SSOCLIM as any SUPER group user.
You must run SSOCLIM twice, once with the root username and hpnonstop password, and
once with the user username and clim password.
a. At a TACL prompt, log on as any SUPER group user.
b. Enter SSOCLIM.
The script prompts you for the CLIM name or IP address of the CLIM. Enter that parameter.
Then the script prompts you for the username and password. Use the root username
and hpnonstop password.
c. Re-enter the SSOCLIM command using the user username and clim password.
2. Use CLIMRSTR to restore all the CLIMs with the CLIM backup files from the previous CLIM
version. Restore the files that you stored when you followed the CLIM software upgrade
procedures in “Back Up CLIM Configuration Files” (page 65).
NOTE: The CLIM configuration files used during this procedure must be of the same RVU as
the RVU to which you are falling back.
For the H06.16 RVU, rename and restore the backup files. For example, at the TACL prompt,
enter:
a. >FUP RENAME $DATA1.BCKH0616.N100251, $DATA1.BCKH0616.BACKUPGZ
b. >CLIMRSTR N100251 $DATA1.BCKH0616
c. Repeat steps a. and b. for each CLIM.
For H06.17 and later RVUs, restore the backup files. For example, at the TACL prompt, enter:
a. >CLIMRSTR N100251 $SYSTEM.N10251.BCKH0617
b. Repeat for each CLIM.
3. Reboot the CLIMs:
a. For large systems, boot one of every pair of CLIMs on the system at the same time.
NOTE: For IP and Telco CLIMs, you must know which CLIMs are configured as failover
pairs. For Storage CLIMS, you must know which pair of CLIMs are attached to a particular
path or you will lose access to the disk.
b. Wait for all the CLIMs to be restored and wait for disk paths or IP addresses to return
before rebooting the next CLIM.
For Storage CLIMs, use SCF status disk $*. For IP and Telco CLIMs, use CLIMCMD
psclim.
>climcmd n100251 psclim
154 Falling Back on the CLIMs, Loading the Previous RVU, and Resuming Normal Operations