H06.19 Software Installation and Upgrade Guide

Table 9 Upgrade Checklist (continued)
Done?ReferenceTask Description
“Receive New Software Into the Archive” (page 77)7. For those with NonStop Software
Essentials, receive the RVU SUT into
DSM/SCM software archive
“Receive New Software Into the Archive” (page 89)8. For those with DSM/SCM Planner
Interface, receive this RVU SUT into
DSM/SCM software archive.
“Create a New Software Revision” (page 79)9. For those with NonStop Software
Essentials, create this RVU software
configuration revision.
“Create a New Software Revision” (page 93)10. For those with DSM/SCM Planner
Interface, create this RVU software
configuration revision.
“Build and Apply the New Software Revision” (page 82)11. For those with NonStop Software
Essentials, build and apply this RVU
software revision.
“Build and Apply the New Software Revision” (page 96)12. For those with DSM/SCM Planner
Interface, build and apply this RVU
software revision.
“Print Operator Instructions From the Target Interface
(ZPHITI)” (page 100)
13. Print DSM/SCM Operator
Instructions.
Chapter 8: “Running ZPHIRNM ”14. Run ZPHIRNM.
“2. Halt the Processors” (page 112)15. Halt processors.
Cluster I/O Protocols (CIP) Configuration and
Management Manual
16. Update CLIM software on all
CLIMs using the procedure Performing
the CLIM Software Upgrade Using
OSM Low-Level Link. (If you are
migrating from H06.17 or later and
performed an online upgrade of the
CLIM to the CLIM software released
with this RVU before starting the host
system upgrade, you can skip this
step.)
“6. Loading the System” (page 112)17. Load system with this new RVU.
“Managing Maintenance Entity (ME) Firmware and ME
FPGA Firmware” (page 26) and the CSSI web page
18. Update ME and ME FPGA
firmware, if necessary.
“Managing NonStop Blade Complex Firmware”
(page 29)
19. Update NonStop Blade Complex
(NSBC) firmware.
“Managing ServerNet Adapter Firmware” (page 33)20. Update G4SA Download Code
firmware, if necessary.
“Managing ServerNet Adapter Firmware” (page 33)21. Install ISP1040 firmware, if
necessary.
“Managing ServerNet Adapter Firmware” (page 33)22. Update FCSA firmware, if
necessary.
“Managing CLIM Firmware” (page 36)23. Update firmware for CLIM
components as needed.
“Update NonStop TCP/IP Configuration Files” (page 120)24. Recover the TCP/IP files, if
necessary.
“Check Processor Status ” (page 67)25. Check processor status.
Upgrade Checklist 63