H06.20 Software Installation and Upgrade Guide

The 608002-004 edition contained a change to Step 3 in “Complete CLIM Setup” (page 155) for

the need to reboot Storage CLIMs after executing the clearlog command.

The 608002-003 edition contained these changes:

• “Check or Alter the CONFTEXT File Before Installing This RVU SUT ” (page 23) is updated to

reference the J06.nn Software Installation and Update Guide for NonStop NS2000 systems.

• “Managing SWAN and SWAN 2 Concentrator Firmware” (page 36) is updated to reference

either the SWAN Concentrator Installation and Support Guide or the SWAN 2 Concentrator

Installation and Support Guide.

• Duplicate information has been removed from “Installation, Migration, and Fallback

Considerations” (page 38).

• “DSM Tape Catalog Migration” (page 56) has been added to “H06.13” (page 56) in Chapter

• “DSM/SCM Upgrade Issues/Interoperability SPR Requirements” (page 60) has been added

to “H06.18” (page 60) in Chapter 3.

• “Configure the WAN Manager” (page 124) is updated to reference either the SWAN

Concentrator Installation and Support Guide or the SWAN 2 Concentrator Installation and

Support Guide.

• “Complete CLIM Setup” (page 155) is updated for falling back to either the H06.20 RVU or

the H06.19 RVU (or earlier RVUs.)

• “Updating SWAN Concentrator CLIP Firmware” (page 194) is updated to reference either the

SWAN Concentrator Installation and Support Guide or the SWAN 2 Concentrator Installation

and Support Guide.

The 608002-002 edition contained the following changes to clarify CLIM software upgrade:

• “Installation, Migration, and Fallback Considerations” (page 38) was changed to correct the

CLIM interoperability issues that apply to H06.16 and H06.17 and later H-series RVUs.

• “Upgrade Checklist” (page 62) has been changed to eliminate a CLIM reboot step after the

software upgrade step because the reboot occurs during the software update procedure itself

and was therefore redundant as a separate step in the checklist. This section also mentions

that for H06.17 and later RVUs, the CLIMs can be updated online, in advance of the RVU

software installation, and that the steps must be performed in order. Finally, the contingency

that you may have already performed the CLIM software upgrade online before beginning

the RVU upgrade is accounted for in the steps.

• “Loading This RVU” (page 110) was reorganized to make it clear that for an offline upgrade

of CLIMs, you perform the CLIM software upgrade while the processors are halted. As part

of this clarification, “4. (Optional) Upgrade the CLIM Software” (page 113) was made into a

separate step.

Additionally, a change was also made to “H06.20” (page 61).

What This Guide Does Not Cover

• System migration planning. System-wide issues involved in migrating to the latest H-series RVU

are covered in:

◦ The H06.nn Release Version Update Compendium for this RVU

◦ The Interactive Upgrade Guide 2 (IUG2)

• Installing an H-series RVU from a host system to a remote or separate network-connected target

system using an Expand connection or tape. See the NonStop Software Essentials User's

Guide or DSM/SCM User's Guide for information on setting up target systems.

• Installing and configuring HP NonStop Open System Services (OSS).