H06.20 Software Installation and Upgrade Guide

6. For the maintenance provider CLIMs, configure the maintenance provider interface:
a. For the two IP CLIMs configured with a Maintenance Provider (usually the first two IP
CLIMs, for example, N100251/N100252), configure the eth0:0 interface. Using the IP
address and netmask of ZTCP0 and ZTCP1 you collected by using the SCF INFO CLIM
DETAIL and CLIMCMD climconfig interface -info commands (
climcmd climname climconfig interface -info eth0:0
) prior to starting the downgrade, and using the iLO serial console, enter these commands
at the Linux prompt:
climconfig interface -add eth0:0
climconfig ip -add eth0:0 -ipaddress 192.168.36.10 -netmask 255.255.0.0
NOTE: The ipaddress and netmask values in the above command are examples,
and these are provided by the CLIMCMD climconfig interface -info commands; however,
eth0:0 is a hard-coded value for the CLIMs.
7. When you receive the Remote disconnected without sending a disconnect
message, click Ok.
The ProLiant window shows briefly, and then the remote console window returns.
Prepare the CLIMs 153