H06.20 Software Installation and Upgrade Guide

OSM Low-Level Link, reboot the system console, and restart the system load using the OSM
Low-Level Link again.
6. Monitor the system startup process. Messages indicating the progress and completion of the
system load, as well as the reload of processors indicated in the CIIN file, appear in these
display locations on the system console.
When the system load is complete (the operating system is loaded successfully into the memory
of processor 0 or processor 1), the Detailed box on the System Load dialog box displays:
SYSTEM STARTUP COMPLETE,
NSK RUNNING ON PROCESSOR n
• If the system load fails, check for the appearance of any halt codes or messages. For
recovery procedures, see the Processor Halt Codes Manual or Operator Messages Manual.
• After the operating system is running on the server, messages are no longer sent to the
Details box. See the event messages sent to the startup event stream window.
Complete the System Load (If Necessary)
Loading the processors with the CIIN file is usually automatic. However, if the operating system
loaded successfully into processor 0 or processor 1, but the commands in the CIIN file do not
reload all remaining processors, use the TACL RELOAD command as shown in the following steps.
You must be super ID (255,255) to load the processors.
1. From the system console, log on to the system as a super-group user (255,nnn) and enter:
TACL> RELOAD *, PRIME
2. To load an individual processor, enter:
TACL> RELOAD nn
where nn is the processor number of the processor you want to reload.
If the reload is initiated successfully, this message appears in a startup TACL window on the
system console screen:
PROCESSOR RELOAD: nn
If Falling Back to the H06.03 or H06.04 RVU
If you are falling back to the H06.03 or H06.04 RVU, then after loading the previous RVU, finish
loading the rest of the NonStop Blade Complex firmware, as described in step 6c under “Reverting
to H06.03 or H06.04 From This RVU” (page 157).
Complete CLIM Setup
1. Establish trust between the CLIM and the NonStop host system.
For all other RVUs, you can run SSOCLIM as any SUPER group user.
You must run SSOCLIM twice, once with the root username and hpnonstop password, and
once with the user username and clim password.
If Falling Back to the H06.03 or H06.04 RVU 155