H06.20 Software Installation and Upgrade Guide

LDev Primary Backup Mirror MirrorBackup Primary Backup
PID PID
151 *STARTED STARTED *STARTED STARTED 0,332 1,289
STORAGE - Status DISK \ATLAS.$ADBIT
LDev Primary Backup Mirror MirrorBackup Primary Backup
PID PID
150 *STARTED STARTED *STARTED STARTED 0,331 1,290
STORAGE - Status DISK \ATLAS.$ADSAV
LDev Primary Backup Mirror MirrorBackup Primary Backup
PID PID
149 *STARTED STARTED STOPPED STOPPED 0,330 1,291
Total Errors = 0 Total Warnings = 0
$SYSTEM TOOLS 49>
Verify Tape Drives (If Necessary)
You can use SCF commands or OSM to obtain status information about a tape drive. Check that
the tape drive is online before continuing with installing SPRs, RVUs, or RVURs. Note that OSM
does not test tape libraries.
1. Enter the SCF STATUS TAPE command:
> SCF STATUS TAPE $*
2. Verify that the STATUS TAPE display includes a least one tape drive configured and running,
as shown:
STORAGE - Status TAPE $T0150
LDev State Sub State Primary Backup Device Status
PID PID
71 STARTED UP 0,282 1,273 READY
3. Use the SCF STATUS TAPE, DETAIL command to display the current state of the tape drive.
4. If the status of the tape drive is stopped or not ready, start the tape drive and put the tape
drive online.
Verify That the CLIMs Are in the Started State
1. Enter the SCF STATUS CLIM command:
-> STATUS CLIM $ZZCIP.*
2. Verify that the state of all configured CLIMs is STARTED:
CIP Status CLIM \MYSYS.$ZZCIP.*
Name Present State Trace
N100251 Yes STARTED OFF
N100374 Yes STARTED 1, 2
N101254 Yes STARTED 2
Verify That the CIP Providers Are in the Started State
1. Enter the SCF STATUS PROV command:
-> STATUS PROV $ZZCIP.*
2. Verify that the status of all providers is STARTED:
CIP Status PROVIDER
72 Preparing to Upgrade the Server Software (Pre-installation Tasks)