H06.21 Software Installation and Upgrade Guide

NOTE: For detailed information about the appearance of and instructions for using the
wizard you have installed on your NonStop system console, see the online help for that
wizard.
c. Using the wizard, determine whether the CLIMs are being used for DHCP, DNS, and
BOOTP services. If they are, check the listed IP addresses to see if they correspond to the
CLIMs you are downgrading. For information on how to use the wizard, see the online
help for the wizard you are using.
NOTE: If any CLIMs to be downgraded are being used for those services, you will use
this information later, during the fallback step “Migrate CLIM Services and Disconnect
CLIMs” (page 140).
6. Obtain the system name, netmask, gateway, and IP address for the CLIMs. If this information
is unavailable from your environmental documentation, continue with the next step to obtain
it directly from your system. Otherwise, skip the next step.
7. Obtain and record the current CLIM configuration information:
a. Using the SCF INFO CLIM, DETAIL command, obtain the maintenance interface IP address
and NonStop host system name of the CLIM(s) to be downgraded. For example:
->INFO CLIM $zzcip.c100251,detail
CIP Detailed Info CLIM \NSAA11.$ZZCIP.C100251
Mode....................... IP
Configured Location........ Group 100 , Module 2 , Slot 5 , Port 1
ConnPts.................... 2
X1 Location................ Group 100 , Module 2 , Slot 5 , Port 1
Y1 Location................ Group 100 , Module 3 , Slot 5 , Port 1
SvNet ID 1................. 0x000E0DC6
X2 Location................ Group 100 , Module 2 , Slot 5 , Port 2
Y2 Location................ Group 100 , Module 3 , Slot 5 , Port 2
SvNet ID 2................. 0x000E0EC6
Maintenance Interface IP... 16.107.184.198
Network CLIM Information:
Provider................... CSAM2
Index...................... 1
The NonStop host system name in this example is \NSAA11 and the maintenance interface
IP address is 16.107.184.198.
b. Use the climcmd clim-name climconfig interface -info eth0 command
from a TACL prompt for the CLIMs to obtain the netmask and gateway. For example:
20> climcmd c100251 climconfig interface -info eth0
comForte SSH client version T9999H06_17May2009_comForte_SSH_0086
Interface : eth0
Interface Type : Physical Interface
Jumbo Frame : NO
IP Address : 16.107.184.198
Netmask : 255.255.255.0
ROUTE Details :
- Route Type : Default Route
Destination Address : 0.0.0.0
Netmask : 0.0.0.0
Gateway Address : 16.107.184.1
Metric : 0
Minimum RTO : Unspecified
Auto Negotiation Details :
- Status : on
Line Speed : Not Applicable
Duplex : Not Applicable
Before Halting the Processors 139